#25 Chain Tool
Copyright © 2018 REV Robotics, LLC
6
2.2
RESETTING CHAIN
Step 1
Unscrew the pin screw and compression screw such that
they are flush with the chain channel.
Step 2
Insert #25 chain (REV-41-1365) into the chain channel
and align the desired link between the two vertical pins in
the channel.
Step 3
Next secure the chain in place with the compression
screw. Tighten until the chain cannot shift within the
channel.
Step 4
With the chain in place it can now be broken. Screw the
pin screw down until it almost touches the back screw in
the slot. As result of manufacturing tolerances, the cup
point set crew may be close enough to use as a hard stop
for the pin. The user should
stop pushing the pin out
before it leaves the back plate
. A link is needed on one
side and on the other a plate and pin. Considerable
pressure will be felt before the pin comes all the way out.
This is a good time to stop and take the chain out and to
check on the pin. The final result will be the pin still
partially connected to the chain (see photo as example).
Note: Be careful to not overly push the pin out as it will be
impossible to put it back in, and a master link will be
needed.
