Retsch PP 35, Manual

Page: 19 / 48

First Commissioning
19
Fig. 5:
Replace the delivery screw cap with a press-screw cap.

Screw the rear metal-sheet panel on again.

Connect the connection cable to the press and insert it into a shockproof socket.

Pull the PP 35 pellet press tool sliding tray out as far as it will go.

Make sure the tool sliding tray is clean and that there is no feed material in it as this would
destroy the tool sliding tray during the subsequent pressing procedure.

Insert the pressing tool included in the scope of supply into the tool-sliding tray device and
fill the pressing tool.
NOTE
Only work with the pressing tool included in the scope of supply.

Put the cover on the pressing tool and push the tool sliding tray into the press again.

Use the mains switch to turn on the press.

Caution: the emergency-stop switch must be pulled.