Retrofire RF24BN, Installation And Owner'S Manual

Page: 18 / 24

18
Owner’s Information
Automatic ON/OFF
You can set your fi replace to come on before you wake up and turn off after you
leave and then, turn on again just before you come home and turn off after going
to bed.
You can leave it like this for the heating season.
Decide what temperature you want your fi replace to be at. Also, decide what
time you want your fi replace to turn on and off. Finally, decide what time you
want it to come back on and off in the afternoon or evening. For the fi rst few
times you set the timer, it’s handy to write these times down.
Set the temperature (just as you did in the section
Setting the Temperature.)
Press the TIMER button and hold it until P1
☼ appears and flashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace to turn on in the morning.
Press the TIMER button and hold it until P1
☽
appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace to turn off when you leave.
Press the TIMER button and hold it until P2
☼
appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace will turn back on in the afternoon.
Press the TIMER button and hold it until P2
☽
appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace to turn off in the evening.
Note: If you want to set your fi replace for only one time on and off, set P2 ☼ and
P2
☽
for the same times as P1
☽
.
The remote will record the P1
☽
off time for
both P2 times.
To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go back
to manual settings. Press TIMER to go back to your settings.
When your remote control displays BATT , you need to replace the battery with a
new 9 volt alkaline battery—6LR61/MN1604.
1.
2.
3.
4.
5.
6.