Retrofire RF24BN, Installation And Owner'S Manual

Page: 17 / 24

17
Owner’s Information
Please read the
Safety and Warning Information
section at the beginning of this manual.
Operating Your Fire
For your safety, this appliance is fi tted with a fl ame supervision device which will shut-off the gas supply if, for
any reason, the pilot fl ame goes out. This device incorporates a fi xed probe, which senses the heat from the pilot
fl ame. If the probe is cool, the device will prevent any gas fl ow unless the burner control knob is kept pushed in at
the PILOT position. See
Lighting Instructions
section on page 20 of this manual.
Setting the Time
The fi rst thing to do is to set the time.
With your thumb, hold down both the AUTO and TIMER buttons until F fl ashes.
Let go.
Note the digital clock on the bottom right hand corner. The
▲
button sets the hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is fl ashing. If it stops fl ashing,
go back to 1.
The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the
AUTO button while the display fl ashes.
Let go and wait until the fl ashing stops. The remote shows the time you set. It
also shows the current temperature.
Setting the Temperature
Use this setting when you come in and want to enjoy a speci fi c temperature.
Push the AUTO button until a number and F fl ash. Let go.
While it is still fl ashing, push the ▲ and ▼ buttons to the temperature you
want. Let go.
Your fi replace will reach that temperature and the remote will check the temperature
every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even
heat.
Setting the Flame
Use this setting when you want a particular fl ame level. For instance, you want to
watch fl ames burn at their highest level and you don’t mind if the room is too hot.
To raise the fl ame, press and hold the ▲ button until the flame gets to the
desired level. Let go.
To lower the
fl ame, press and hold the ▼ button until the fl ame gets to the
desired level. Let go.
The fl ame level will remain just as you set it.
1.
2.
3.
4.
1.
2.
1.
2.
Programmable Remote Control
Your fi replace remote control helps you get the comfort, convenience and
aesthetics you want from your gas fi replace. The remote system controls your
fi replace in different ways.
IMPORTANT:
BEFORE YOU BEGIN, please note that on this system,
the settings of time, temperature and automatic ON/OFF can only be
programmed when the function display is fl ashing. Be patient when
programming as it can take a few seconds to set.