DCS CODE
023
025
026
031
032
036
043
047
050
051
053
054
065
071
072
073
074
114
115
116
122
125
131
132
134
143
145
152
155
156
162
165
172
174
205
212
223
225
226
243
244
245
246
251
252
255
261
263
265
266
271
274
306
311
315
325
331
332
343
346
351
356
364
365
371
411
412
413
423
431
432
445
446
452
454
455
462
464
465
466
503
506
516
523
526
532
546
565
606
612
624
627
631
632
645
654
662
664
703
712
723
731
732
734
743
754
-
-
-
-
-
-
Function 2:
TONE Search Scanning
In operating situations where you don’t know the CTCSS/DCS tone being used by another station or stations, you can command the radio
to listen to the incoming signal and scan in search of the tone being used.
Enter Menu 29st/30nd to start CTCSS/DCS searching.
If the Tone scan feature does not detect a tone or code, it will continue to scan
indefinitely. When this happens, it may be that the other station is not sending any tone.
You can press
PTT
key to halt the scan at any time.
You also can press
MONI
key during Tone scanning to listen to the (muted) signal from
the other station. When you release the
MONI
key, Tone scanning will resume.
Tone Scanning works either in the VFO or MR modes.
Function 3:
TONE Calling (1750Hz)
If the repeaters in your country require a 1750Hz burst tone for access (typically in Europe), you can press and hold Side Key 1 for 2S and
transmitter will automatically be activated, and a 1750Hz audio tone will be superimposed on the carrier. Once access
to the repeater has been gained, you may release Side Key 1 and use PTT key for activating. The transmitter
21) VFO Step setting (STEP---MENU 27)
Functions:
setting of the synthesizer steps
Enter Menu 27th to set VFO step.
Available Values: 2.5/6.25/10/12.5/25/50/100kHz.
If you would like to set a frequency like 449.4250 as transmit frequency, there are two method to achieve.
Method 1:Under VFO Mode, press MONI key and hold on, input the desire frequency 449.4250,then release the MONI key, the frequency
would be stored to current transmission frequency.
Method 2:Under VFO mode, enter menu 22 to set magnitude of the repeater shift,synthesizer steps can be changed through menu item 27 .
Note: You do not need to hold down the monitor button when changing the receiving frequency.
22) Wide/Narrow band selecting (N/W---MENU 28)
Functions:
setting of wide/narrow bandwidth
Enter Menu 28th to set bandwidth.
Available Values: Wide---25kHz/Narrow---12.5kHz
23) Scrambler(SCR—MENU 31)
Functions:
only 2/5 tone version has this function.This transceiver has 8 groups of scrambler. It is accomplished by the addition of
components to the original signal in order to make a extraction of the original signal difficult. And its voice compand technology will make the
voice more clearly in the noise environment.
Enter Menu 31td to set scrambler group.
24)Dual Watch/Monitor(DW-MENU 34)
Function:
Dual Watch feature makes transceiver can monitor the calling signal when FM radio is on and you won’t miss any calling.
Enter Menu 34th to set DW. Defult:OFF.
11
