background image

Instruction Manual

8

TROUBLESHOOTING GUIDE

WARNINGS

RACER TIPS

Question: I installed the batteries in my transmitter, but the power lights do not come on:

Answer: 

- Check that the batteries are properly installed by checking the polarity (+ and -).

Question: My radio has power, but I have no control:

Answers: 

- Make sure that the power switch is on and connected to the receiver.

- Make sure that the batteries are charged (Replace or recharge if needed.) 

- Make sure that you are using the proper crystals.

Question: My vehicle is glitching, or the servos and/or speed control is acting erratically:

Answers:

- Check that there are no radios operating on your channel.

- Make sure your electric motor has capacitors and the commutator is clean and brushes are 

  not worn out. Replace if needed.

- Check for loose screws as metal-to-metal contact can cause interference.

- Make sure your receiver antenna has not been damaged or cut. 

- Make sure that power wires are at least 2" away from the receiver.

- Replace the crystals if needed.

- If all fails, send your system to be serviced, as there may be internal damage.

- Never operate your car or truck in a crowded street with traffic.

- Always extend your transmitter antenna when in operation.

- Always check the battery power indicator before use.

- Do not operate two or more models on the same frequency at the same time.

- Do not operate your model in the rain or run through standing water.

- Do not operate your model within one mile of a radio control racetrack.

- Do not operate your model while under the influence of drugs or alcohol.

- Always turn your transmitter first and off last to prevent lost of control.

- When collapsing your antenna, never push it from the top or it may bend.

- Slower is faster, Do not overdrive your car. A cleaner line around the track is faster than 

  more top speed. Don't overshoot the corners.

- Reduce your steering dual rate if your car is over-steering or "Loose", and increase the rate if 

  your car is under-steering or "Pushing."

- Add more drag brake (see Steering and Throttle trims) if your vehicle is "Pushing" into the corners. 

  Move the trim the other direction so your car creeps forward slightly when the throttle is at neutral if 

  your car is "Loose" when entering the corners.

- The most important thing to remember is to have fun!

Austria, Belgium, Denmark, Finland, 

France, Germany, Greece, Iceland,

Ireland, The Netherland, Italy, Spain, 

Norway, Portugal, United Kingdom, 

Luxembourg, Sweden, Switzerland

Made in the philippines

Zebra 2 AM Instruction Manual

Summary of Contents for 2 AM

Page 1: ...traffic Always extend your transmitter antenna when in operation Always check the battery power indicator before use Do not operate two or more models on the same frequency at the same time Do not operate your model in the rain or run through standing water Do not operate your model within one mile of a radio control racetrack Do not operate your model while under the influence of drugs or alcohol...

Page 2: ...BATTERY POWER NEUTRAL POSITION ADJUSTMENT FOR THROTTLE SMT CIRCUITRY Size 174X168mm 6 85X6 61in Weight 330g 11 63oz Power supply 7 2V 6 cell Nicad NiMh battery or 6cell Dry battery TRANSMITTER ANTENNA CARRYING HANDLE LED INDICATOR TRANSMITTER CRYSTAL THROTTLE CONTROL STICK NEUTRAL POSITION ADJUSTMENT LEVER THROTTLE TRIM LEVER STEERING TRIM LEVER STEERING CONTROL STICK POWER ON OFF SWITCH THROTTLE ...

Page 3: ... speed controller that has the option of the B E C battery eliminator circuit receiver batterys are not needed on this since motor battery will feed the receiver and servos through the speed control When installing radio system on your R C car please follow the instruction included in your R C car BATTERY COVER TO OPEN THE BATTERY COVER OF THE ZEBRA 2 AM YOU NEED TO PRESS THIS AND PUSH IT DOWNWARD...

Page 4: ...ransmitter before you change the shunt switch 5 If you wish to have more forward throttle stick movement push down the neutral position adjustment lever this will give 30 more forward movement Antenna Both the transmitter and the receiver antennas must be fully extended Do not cut off any excess receiver antenna wire or bundle it up as this will cut down on the operating range of the system Water ...

Reviews: