10
Restek Corporation
Troubleshooting, Maintenance, and Repair
General Maintenance
The electronic crimper tools do not contain user serviceable parts except for the battery pack.
When cleaning or replacing the battery make sure to keep fingers away from the jaws!
Cleaning
The crimping tool may not be immersed in water or solvent. The outside of the case may be
cleaned with an ordinary detergent and wiped off with a damp rag. Care should be taken not to
get the electronics, the battery, or the battery connections wet.
Avoid permitting metal parts of the crimping tool come into contact with corrosive material
during use. If they do, try to wipe them clean with a suitable mild neutralizing solution.
Battery Replacement
Use only the specified 6.4 volt replacement battery pack, part number 22362. Use of
other batteries may cause fire during charging or use
1)
Remove screw holding
the battery cover in place,
4)
Push down on
connector latch and
pull battery loose
from the board.
3) Pull battery out of case,
leaving wire connected.
5)
Connect new battery to board, making sure the latch is
secure. Push battery into case, bending the wires if
necessary.
6) Slide the cover back into the case and replace the
retaining screw.
2)
Remove battery cover
