resideo Braukmann MHF49, Installation Instructions Manual

Page: 6 / 14

GB
6 MU1H-1555GE23 R0420
• Mark the length of the pipe section to be removed
using the cutting ruler on the edge of the packaging
sleeve at hand.
• Make sure there is adequate room to rotate the filter
and access it for cleaning purposes.
Installation of filter connection
1. Connection thread
2. washer
3. Isolation valve
• Fit the isolation valve using the compression fittings
and rings provided. Ensure correct assembly and do
not make watertight yet.
Check flow direction
1. Diverter body
• Check flow arrow direction on diverter body and
ensure it is the same as the pipe work flow direction.
• Fit diverter body using flat washers provided.
• Tighten water tight using spanner.
• Position the diverter valve including the isolation valve
correctly.
• Make the compression connections water tight.
Assemble MHF49
1. MHF49
2. Large fastening ring
3. Lock ring
4. O-ring
5. Diverter
• Fasten MHF49 [1].
• Adjust mounting position vertically.
• Make certain that the O-ring [3] is correctly positioned.
• Tighten the large fastening ring [2] hand tight.
• Filter body must be installed vertically as shown.
• Unscrew the air vent cap from the top of the filter
housing. Open only the inlet isolation valve until water
exits the air vent hole.
• Close the isolation valve.
• Screw the the air vent cap back on water tight.
• Open both isolation valves.
6 Cleaning / Maintenance
6.1 Cleaning cycle
• Before the beginning of each heating period
• For every maintenance of the heating system
• In case of heating system malfunctions
1
2
3
4
5