Resco StormCube-R version. Step-by-step Installation Guide. January 2018
8
RETURN VERSION
Step
10
From the Resco shop drawings,
mark the centers for the floor mount on the chalk line.
Step
11
Centre the floor mounts in place and drill the 2 side
holes to fix in place.
Use 5mm masonry drill bit in concrete
floor and 3.5mm drill bit in wood floor or a
diamond drill bit for Tiles.
Place (F) plastic anchor in hole. Secure floor
mount, using (A)8GA x 32 screws.
Trim Style to fit
Step
12
Full-Stiles
Use a laser level (or string line) between the tops of the
½
Stiles.
a.
Trim all Stiles to height, by putting each Stile upside
down over the appropriate floor mount, mark and
then trim.
Floor mount brackets located in position. (Indicative only. Not to scale.)
Step
13
Hold in place corner channel Fascia with one rivet flush
with the bottom and then plumb.
Use 3.5mm drill bit with (D) Stainless Steel
Pop Rivet 30mm from the top.
Sit in place the Return Headrail.
a.
Ensure the Headrail is touching the walls perfectly.
b.
Drill 3.5mm holes, 200mm apart through the head
rail and into the top of the return panel. Be careful
not to drill through the side of the panel.
Use a 3.5mm drill and fix with (E) 8GA x 20
counter sunk screws.
Step
14
Install wall ½ Stile Fascia using Polymer as you did for
the Return panel in Steps 6 and 7.
Headrail - Sit in place.
a.
Ensure the Headrail is touching the walls perfectly.
The mitre should be perfect from the earlier step.
b.
Fix Headrail to side
½
Stiles.
Use 3.5mm drill bit with (D) Stainless Steel
Pop Rivets.
Step
15
