63
Fixscreen
®
150 (F)
en
11 • Final check for coupled Fixscreen
®
➍
If the motor cable is visible and installed outdoors, the cable needs to be protected by
conduit or trunking which is sun resistant. Check that the end points are set. If they are not
set, set the end points so the motor automatically stops in the desired highest and lowest
position.
➎
Make sure to set the lower end point at 10 mm from the end of the side channels so the
fabric remains at the correct tension.
Check if all screws, bolts and nuts are firmly tightened
➏
Lower the bottom rail to its lowest position.
Check if both bottom rails are aligned at the same height. If not, please go back to 11.2.
➐
Check if all screws, bolts and nuts are firmly tightened.
➑
Roll the screen up and down several times to ensure proper operation.
➊
See point 10.1 (final check single screen)
Release the Allen head screws at the side of the lower fabric
roller and turn the roller so the fabric grooves are accurately
aligned.
Make sure that the indication line on the coupling piece is never
outside the indicated area on the fabric roller end piece.
Put back the front section of the coupling side channels
(Allen key no. 3).
Check if the bottom rails are at the same height.
If not, they can be adjusted on the non-motorised fabric roller.
Both must be symmetrical, i.e. the fabric grooves of both fabric
rollers must align perfectly.
The screens must also be wound on an equal number of turns,
so both bottom rails align perfectly.
➋
➌
Indication line
