Safety notes
The units are shipped in sturdy
transport packaging. Immediately
check the units on delivery and
make a note of any damage or
missing parts on the delivery note.
Inform the forwarding agent and
contractual partner.
Claims under guarantee made at
a later date will not be accepted.
Transportation and
packaging
Environmental
protection
and recycling
Disposal of packaging
All products are packed for
transport in environmentally
friendly materials. Make a valuable
contribution to reducing waste
and sustaining raw materials. Only
dispose of packaging at approved
collection points.
Disposing of the units
and their components
Only recyclable materials are used
to manufacture the units and
components.
Help protect the environment
by ensuring that the units or
components (for example
batteries) are not disposed of
in household waste, but only in
accordance with local regulations
and in an environmentally safe
manner, e.g. using authorised
disposal and recycling specialists or
council collection points.
Carefully read this Operating
Manual before starting the unit for
the first time. It contains
useful tips and notes as well as
hazard warnings to prevent injury
to persons or material damage
. Failure to follow the directions
in this Manual can endanger
persons, the environment and the
equipment itself and will void any
claims for liability.
■
Keep this manual close to the
units.
■
The units and components
should not be exposed to any
mechanical load or extreme
levels of humidity or sunlight.
■
Only qualified personnel may
set up and install the units and
components.
■
The unit and its components
must be set-up, connected and
operated in accordance with the
use and operating conditions
stipulated in this manual and
comply with all applicable local
regulations.
■
Mobile units must be set up
securely on suitable surfaces and
in an upright position. Stationary
units must be permanently
installed for operation.
■
Modification of the units
and components supplied by
REMKO is not permitted and
can cause malfunctions.
■
Units and components may
not be operated in areas where
there is an increased risk of
damage. Observe the minimum
clearances.
■
The electrical power supply is to
be adapted to the requirements
of the units.
■
The operational safety of
the units and components
is only assured if they are
fully assembled and used as
intended. Safety devices may
not be modified or bypassed.
■
Do not operate units or
components with obvious
defects or signs of damage.
■
All housing parts and unit
openings, e.g. air inlets and
outlets, must be free from
foreign objects, liquids, or gases.
■
The units and components must
be kept at an adequate distance
from flammable, explosive,
combustible, abrasive and dirty
areas or atmospheres.
■
Contact with some parts of the
unit or components can result in
burns or other injuries. Wearing
appropriate protective clothing
is necessary to avert risks.
■
Only authorised and trained
persons are permitted to access
and operate the units and
components.
■
Installation, repair and
maintenance work may only
be carried out by authorised
specialists. Visual inspections
and cleaning can be performed
by the operator as long as the
unit is disconnected from the
power.
■
To preclude any risks to persons
originating from the units,
appropriate precautions must
be taken when installing,
repairing, maintaining, cleaning
or working on the units.
REMKO KWK -4R
4
Summary of Contents for KWK 100-4R
Page 2: ......
