![background image](http://html1.mh-extra.com/html/remington/rem-200v-lpc-o/rem-200v-lpc-o_users-manual-and-operating-instructions_1438383009.webp)
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
© 2017, Pinnacle Climate Technologies, Inc.
Convection Heater User's Manual
Lighting Instructions:
REM-80V-LPC-O
1.
STOP! Read all of the safety information
provided with this heater.
2.
Turn valve on propane cylinder
COUNTERCLOCKWISE until fully open.
3.
Press in control knob and turn
COUNTERCLOCKWISE to
LOW/IGN
position.
4.
If burner does not ignite, turn control knob to
OFF
position and repeat the ignition procedure.
5. Keep control knob pressed in for approximately
30 seconds before releasing.
6.
If the flame goes out, wait 5 minutes and
repeat the ignition and lighting steps.
7.
After heater ignites, turn the control knob to
desired heat setting.
Relighting Instructions
1.
Rotate valve on cylinder
CLOCKWISE
to close
it and wait 5 minutes.
2.
Relight following the Lighting Instructions,
steps 1-7.
Shut Down Instructions
1.
Turn control knob to the
OFF
position.
2.
Rotate valve cylinder
CLOCKWISE
to close it.
REM-200V-LPC-O
1.
STOP! Read all of the safety information
provided with this heater.
2.
Turn valve on propane cylinder
COUNTERCLOCKWISE until fully open.
3.
Set control valve to
LIGHT/LOW
position,
then wait 15 seconds before step 4.
4.
Depress the red button on the safety valve,
admitting gas to the burner. While pressing
the safety valve, push and release the ignition
button until the burner lights.
5. When the burner lights, continue to keep the
red safety valve depressed for 30 seconds
then release.
6.
If burner goes out, wait 5 minutes and repeat
lighting procedure.
7.
When burner lights, you can now adjust the
heat setting to
HIGH
by sliding the control
valve up to the
HIGH
setting.
NOTE:
When adjusting heat setting, the control
valve only needs to slightly slide up to achieve
HIGH
setting.
Relighting Instructions
1.
Rotate valve on cylinder
CLOCKWISE
to close
it and wait 5 minutes.
2.
Relight following the Lighting Instructions,
steps 1-7.
Shut Down Instructions
1.
Rotate valve cylinder
CLOCKWISE
to close it.
Operation
EXTREMELY HOT during operation. Do Not touch any metal components while in
operation. Keep gasoline and any other flammable liquids away from the heater.
WARNING
8