© 2021 Pinnacle Climate Technologies, Inc.
Propane Forced Air Heater User’s Manual
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
5
ALWAYS install the heater so that it is not directly exposed
to water spray, rain, dripping water, or wind.
–
Use heater in accordance with all local codes. In
the absence of local codes, refer to The National
Fuel Code, ANSI A223.1/NFPA 54.
–
This heater is shipped from the factory for use
with propane (LP) gas only. Do not convert to
any other gas. Installation must conform to local
codes, or in their absence, with the standard for
the Storage and Handling of Liquefied Petroleum
Gases ANSI/NFPA 58 and the Natural Gas and
Propane Installation Code CSA B149.1.
–
Gas supply connections should be checked by
using a 50/50 soap and water solution. Never use a
flame to check for gas leaks.
–
Locate LP cylinder at least 6 ft. (183 cm) (10 ft./305
cm in Canada) from the heater, and do not direct
heater discharge towards the LP cylinder unless it
is at least 20 feet (610 cm) from the heater.
–
Use only the regulator and hose assembly provided
with this heater. Inspect the regulator/hose
assembly prior to each use of the heater. If there
is excessive abrasion or wear, or if the hose is cut,
replace it with the proper assembly shown in the
parts list, prior to using the heater.
–
The hose assembly shall be visually inspected
prior to each use of the heater. If it is evident there
is excessive abrasion or wear, or the hose is cut, it
shall be replaced prior to the heater being put into
operation. The replacement hose assembly shall
be that specified by the manufacturer.
Manifold, Minimum, and Maximum Inlet Pressure
40-GFA
60V-GFA 125V-GFA
150V-GFA
Man.
11" (279
mm) W.C.
11" (279
mm) W.C.
8.3" (211
mm) W.C.
8" (203
mm) W.C.
Min.
5 PSI (34.5 kPa)
Max.
Bottle Pressure
For use with propane
(LP) gas only.
WARNING
Electrical Grounding In-
structions: This appliance is
equipped with a three-prong (grounding) plug for
your protection against shock hazard and should be
plugged directly into a properly grounded three-
prong receptacle.
RISK OF ELECTRIC SHOCK!
SAFETY INFORMATION (CONT.)
The hose assembly shall be
pro tected from traffic, building
material and contact with hot surfaces both during
use and while in storage.
X
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
RISK OF FIRE! DO NOT POSITION HEATER IN A DOWNWARD ANGLE. ALWAYS
LOCATE HEATER ON A STABLE AND LEVEL SURFACE (SEE FIGURE 1)!
Figure 1
UNPACKING
1. Remove all packing items applied to heater for shipment.
Keep plastic cover caps attached to inlet connector and
hose / regulator assembly for storage.
2. Remove all items from carton
3. Check all items for shipping damage. If the heater is
damaged, promptly inform dealer where you purchased
the heater.
The Propane (LP) gas
pressure regulator
and hose assembly
supplied with the heater must be used without
alteration.
CAUTION
WARNING
WARNING
WARNING
WARNING
