![background image](http://html.mh-extra.com/html/remington/pro-power-hc5150/pro-power-hc5150_instructions-for-use-manual_1437902006.webp)
4
CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality blades. To ensure long lasting performance of your clipper,
clean the blades and unit regularly. Always keep the attachement guide comb on the trimmer
blade.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Gently brush the remaining hairs away from the trimmer comb and trimmer blade.
Do not rinse the cutter assembly under water.
NOTE: Ensure that the clipper is turned off when cleaning.
CLEANING CAUTIONS
Only the adjustable trimmer comb and cutter assembly may be removed from the trimmer
for cleaning.
Cleaning should only be done with a soft brush, such as the brush supplied with the product.
Only use the light-grade oil supplied or sewing machine oil on the blades.
Do not use harsh or corrosive cleaners on the units or their cutters.
Do not apply pressure or hard objects to cutters.
Do not disassemble cutter assembly.
Do not submerge in water as damage will occur.
NOTE: Ensure that the hair clipper is turned off when cleaning.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove bladeset.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade from
the unit.
If the moving blade has been removed this can be re-fitted by slotting the coated blade holder
over the pin in the centre of the interior product head. The groove on the coated blade, just
below the teeth, rests on a metal plate at the opposite side to the screw holes. The fixed
blade is fitted with the raised profile pointing outwards and fixed with the 2 screws.
Note that if the blades are not correctly aligned then cutting efficiency will be impaired.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
ENGLISH
100156_REM_IFU_HC5150_21L.indd GB_4
100156_REM_IFU_HC5150_21L.indd GB_4
29.03.10 15:34
29.03.10 15:34