![background image](http://html.mh-extra.com/html/remington/hc5018/hc5018_quick-manual_1437853004.webp)
4
TO ATTACH A COMB
1. Hold the comb with its teeth upward.
2. Slide it onto and along the clipper blade until the front of the comb firmly sits
against the clipper blade.
3. Gently push the back of the comb down so it snaps into place.
TO REMOVE THE COMB
•
Holding the clipper with the blades facing away from you, firmly push the comb
upward and away from the blades.
Guide Combs
Hair Length
1 (Grade 1)
3mm
2 (Grade 2)
6mm
3 (Grade 3)
9mm
4 (Grade 4)
12mm
5 (Grade 5)
18mm
•
Each comb attachment is marked accordingly on its outside middle surface (3mm,
6mm, 9mm, 12mm, 18mm).
•
Use the clipper without any fixed combs for trimming hair close to the skin.
•
This will trim hair to 1mm, holding the clipper so the blades are perpendicular to
the skin will trim hair to 0.5mm.
•
This is with the taper setting set at the closest gap between the blades.
INSTRUCTIONS FOR CUTTING HAIR
For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the first time, start with the maximum
comb attachment.
STEP 1 – NAPE OF THE NECK
1. Use 3mm or 6mm guide comb.
2. Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre
of the head at the base of the neck.
3. Slowly lift the clipper, working upwards and outwards through the hair, trimming
just a little at a time.
STEP 2 – BACK OF THE HEAD
With the 12mm comb attached, cut the hair at the back of the head.
STEP 3 – SIDE OF THE HEAD
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
12mm or 18mm guide comb and continue to cut up to the top of the head.
Summary of Contents for HC5018
Page 2: ...f e g ...