background image

3.  Gently tap the shaver head on a 

flat

 surface to remove any 

loose hair particles, and rinse the shaver head under warm 
water (Diagram J). Never submerge your 
shaver under water.

4.  Thoroughly clean the cutter and trimmer 

with a brush (Diagram J).

5.  Never use the cleaning brush on the foils, 

as damage may occur.

6.  Shake off any excess water.
7.  Leave the shave unit open to allow the 

shaver to  dry completely.

8.  Lubricate the shaver with a spray of 

Remington® Shaver Saver (SP4) on the 
foil and cutters.

9.  Replace the head assembly, simply by 

pushing it on the shaver. 

Cover shaver head with the protective head guard between 
uses. When removing the head guard or placing it back onto 
the shaver, do not apply pressure to the 

floating

 cutter 

surfaces, as you may damage them.

Lubricate

Remington® Shaver Saver (SP-4) lubricates, cleans and 
protects your shaver’s foil and cutter assembly. The lubricant 
helps remove hair clippings while reducing wear. Spray on the 
foil and cutters after each shave to keep your shaver operating 
at peak performance.

Cleaning Cautions

  Never submerge the shaver completely into water.

  Never clean the shaver or replace the cutters while it is 

plugged into an electrical outlet. 

  Do not use any aggressive cleaning agents, as this may 

damage the shaver.

Replacing Your Heads & Cutters

It is very important to replace your foils and cutters when 

necessary to ensure a close, comfortable shave without 

I

J

irritation. We recommend they be replaced every 6 months for 

optimal performance. Here are some signs of head and cutter 

wear, indicating that replacement is needed.

Signs that your foils and cutters need replacing:

•  Irritation: As foils get worn, you may experience skin irritation. 

As the foils become excessively worn you may experience 

some skin irritation or redness.

•  Pulling: As the cutters wear, your shave may not feel as close 

and you may feel your cutter pulling your hair.

•  Wear through: You may notice that the cutters have worn 

through the foils.

TO REPLACE THE FOIL

•  Pull the foil assembly up to remove from the hair pocket.

•  Insert new foil assembly in hair pocket until it snaps in place.

 

TO REPLACE THE CUTTERS

•  Grasp cutter between thumb and fore finger and pull upward.

•  Snap both new cutter assemblies into top of oscillator tips.

STORAGE

When not in use, always unplug the power adaptor from the 

power outlet. Never wrap the cord of the power adaptor 

around the unit as this will cause the cord to wear prematurely 

and break. Handle the cord carefully for long life and avoid 

jerking, twisting or straining especially at the power plug. If the 

cord becomes twisted in use, periodically straighten it.

2 YEAR

 

WARRANTY

 

F3700AU

MOnEY BACk OFFER - Australia/new Zealand Only

If within 30 days you are not fully satisfied with your 

Remington® shaver, just return the shaver with this completed 

coupon and a copy of your Australian/New Zealand purchase 

receipt to Remington®. In return, we will send you a cheque for 

the full purchase price of the shaver. Please allow 6-8 weeks 

for your cheque to arrive.

Name: 

      

Address:

 

      

City: 

     

State:  

 Postcode:  

12

11

13

14

Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited

WARRAnTY AGAInST dEFECTS

In this warranty:

Australian Consumer Law

 means the Australian consumer law set out in Schedule 2  

to the Competition and Consumer Act 2010;

CGA

 means the New Zealand Consumer Guarantees Act 1993;

Goods

 means the product or equipment which was accompanied by this warranty and 

purchased in Australia or New Zealand, as the case may be;

Manufacturer, We 

or 

us

 means:

1.  for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd  

ACN, 007 070 573; or

2.  for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,  

as the case may be, contact details as set out at the end of this warranty;

Supplier 

means the authorised distributor or retailer of the Goods that sold you the Goods 

in Australia or in New Zealand; and 

You

 means you, the original end-user purchaser of the Goods.

1.  Our goods come with guarantees that cannot be excluded under the Australian 

Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure 
and compensation for any other reasonably foreseeable loss or damage. You are also 
entitled to have the goods repaired or replaced if the goods fail to be of acceptable 
quality and the failure does not amount to a major failure.

2.  The benefits provided by this Warranty are in addition to all other rights and remedies in 

respect of the Goods which the consumer has under either the Australian Consumer Law 
or the CGA. The original purchaser of the Goods is provided with the following Warranty 
subject to the Warranty Conditions:

3.  We warrant the Goods for all parts defective in workmanship or materials for the period 

of two (2) years from the date of purchase

 (Warranty Period)

. If the Goods prove 

defective within the Warranty Period by reason of improper workmanship or material,  
we may, at our own discretion, repair or replace the Goods without charge.

Warranty Conditions

4.  The Goods must be used in accordance with the manufacturer’s instructions. This 

Warranty does not apply should the defect in or failure of the Goods be attributable to 
misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of 
the user. As far as the law permits, the manufacturer does not accept liability for any 
direct or consequential loss, damage or other expense caused by or arising out of any 
failure to use the Goods in accordance with the manufacturer’s instructions.

5.  Exhaustible components (such as shaver heads, cutters and foils) of the Goods  

are included under this Warranty only where there is a defect in workmanship or 
materials used.

6.  The warranty granted under clause 3 is limited to repair or replacement only.
7.  Any parts of the Goods replaced during repairs or any product replaced remain the 

property of the manufacturer. In the event of the Goods being replaced during the 
Warranty Period, the warranty on the replacement Goods will expire on the same date  
as for the Warranty Period on the original Goods which are replaced.

8.  In order to claim under the warranty granted under clause 3 you must:
 

(a)  Retain this warranty with your receipt/proof of purchase; and

 

(b)  Return the Goods to us at the relevant address below or to the Supplier by prepaid 

freight within the Warranty Period accompanied with (i) the legible and unmodified 

original proof of purchase, which clearly indicates the name and address of the 

Supplier, the date and place of purchase, the product name or other product serial 

number and (ii) this warranty.

9.  This warranty is immediately void if:
 

(a)  Any serial number or appliance plate is removed or defaced;

 

(b)  The Goods have been serviced or otherwise repaired by a person not authorised to 

do so by us or where non approved replaced parts are used.

10.  The Goods are designed for domestic use only. A limited 90-day Warranty applies to any 

industrial or commercial use of the Goods. The Goods must be connected to the electrical 

voltage requirements as specified in the ratings label located on the Goods.

11.  This warranty does not cover the cost of claiming under the warranty or transport of the 

Goods to and from the Supplier or us.

12.  This warranty is only valid and enforceable in Australia against Spectrum Brands 

Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.

Contact us or the Supplier for further details.

Spectrum Brands Australia Pty Ltd 

Chifley Business Park 
1 Chifley Drive 
Mentone, VIC 3194 Australia 
Customer service in Australia: 1800 623 118 
E-mail: [email protected] 
Website: www.remington-products.com.au

Spectrum Brands new Zealand Limited 

Building C, Ground Floor 
600 Great South Road, 
Greenlane, Auckland 1051 New Zealand 
Customer service in New Zealand: 0800 736 776 
E-mail: [email protected]

Website: www.remington-products.com.au

REMInGTOn SERVICE HOTLInE

 

Australia 1800 623 118 (toll free) 

 

New Zealand 0800 736 776 (toll free)

AUTHORISEd REPAIR CEnTRES

Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trademark of Spectrum Brands, Inc. (SBI), or one of its subsidiaries
Manufactured to Spectrum Brands specifications in the PRC
© 2012 SBI
Rev.05/12
Part No. T22-0000311

USE & CARE 

MANUAL

PLEASE READ

PRIOR TO USE

TOOLS OF THE TRADE

 

FOIL SHAVER

This product is not suitable to use in a bath or shower. 

The shaver conforms to radio frequency  

interference requirements.

Any product purchased and used commercially 

 

carries a limited 90 Day Warranty.

10

9

F3700AU_IFU_FA_170712.indd   1-7

17/07/12   11:42 AM

Summary of Contents for F3700AU















Reviews: