3. Gently tap the shaver head on a
flat
surface to remove any
loose hair particles, and rinse the shaver head under warm
water (Diagram J). Never submerge your
shaver under water.
4. Thoroughly clean the cutter and trimmer
with a brush (Diagram J).
5. Never use the cleaning brush on the foils,
as damage may occur.
6. Shake off any excess water.
7. Leave the shave unit open to allow the
shaver to dry completely.
8. Lubricate the shaver with a spray of
Remington® Shaver Saver (SP4) on the
foil and cutters.
9. Replace the head assembly, simply by
pushing it on the shaver.
Cover shaver head with the protective head guard between
uses. When removing the head guard or placing it back onto
the shaver, do not apply pressure to the
floating
cutter
surfaces, as you may damage them.
Lubricate
Remington® Shaver Saver (SP-4) lubricates, cleans and
protects your shaver’s foil and cutter assembly. The lubricant
helps remove hair clippings while reducing wear. Spray on the
foil and cutters after each shave to keep your shaver operating
at peak performance.
Cleaning Cautions
•
Never submerge the shaver completely into water.
•
Never clean the shaver or replace the cutters while it is
plugged into an electrical outlet.
•
Do not use any aggressive cleaning agents, as this may
damage the shaver.
Replacing Your Heads & Cutters
It is very important to replace your foils and cutters when
necessary to ensure a close, comfortable shave without
I
J
irritation. We recommend they be replaced every 6 months for
optimal performance. Here are some signs of head and cutter
wear, indicating that replacement is needed.
Signs that your foils and cutters need replacing:
• Irritation: As foils get worn, you may experience skin irritation.
As the foils become excessively worn you may experience
some skin irritation or redness.
• Pulling: As the cutters wear, your shave may not feel as close
and you may feel your cutter pulling your hair.
• Wear through: You may notice that the cutters have worn
through the foils.
TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert new foil assembly in hair pocket until it snaps in place.
TO REPLACE THE CUTTERS
• Grasp cutter between thumb and fore finger and pull upward.
• Snap both new cutter assemblies into top of oscillator tips.
STORAGE
When not in use, always unplug the power adaptor from the
power outlet. Never wrap the cord of the power adaptor
around the unit as this will cause the cord to wear prematurely
and break. Handle the cord carefully for long life and avoid
jerking, twisting or straining especially at the power plug. If the
cord becomes twisted in use, periodically straighten it.
2 YEAR
WARRANTY
F3700AU
MOnEY BACk OFFER - Australia/new Zealand Only
If within 30 days you are not fully satisfied with your
Remington® shaver, just return the shaver with this completed
coupon and a copy of your Australian/New Zealand purchase
receipt to Remington®. In return, we will send you a cheque for
the full purchase price of the shaver. Please allow 6-8 weeks
for your cheque to arrive.
Name:
Address:
City:
State:
Postcode:
12
11
13
14
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRAnTY AGAInST dEFECTS
In this warranty:
Australian Consumer Law
means the Australian consumer law set out in Schedule 2
to the Competition and Consumer Act 2010;
CGA
means the New Zealand Consumer Guarantees Act 1993;
Goods
means the product or equipment which was accompanied by this warranty and
purchased in Australia or New Zealand, as the case may be;
Manufacturer, We
or
us
means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier
means the authorised distributor or retailer of the Goods that sold you the Goods
in Australia or in New Zealand; and
You
means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and remedies in
respect of the Goods which the consumer has under either the Australian Consumer Law
or the CGA. The original purchaser of the Goods is provided with the following Warranty
subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the period
of two (2) years from the date of purchase
(Warranty Period)
. If the Goods prove
defective within the Warranty Period by reason of improper workmanship or material,
we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable to
misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of
the user. As far as the law permits, the manufacturer does not accept liability for any
direct or consequential loss, damage or other expense caused by or arising out of any
failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods
are included under this Warranty only where there is a defect in workmanship or
materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
property of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same date
as for the Warranty Period on the original Goods which are replaced.
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid
freight within the Warranty Period accompanied with (i) the legible and unmodified
original proof of purchase, which clearly indicates the name and address of the
Supplier, the date and place of purchase, the product name or other product serial
number and (ii) this warranty.
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not authorised to
do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any
industrial or commercial use of the Goods. The Goods must be connected to the electrical
voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty or transport of the
Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Chifley Business Park
1 Chifley Drive
Mentone, VIC 3194 Australia
Customer service in Australia: 1800 623 118
E-mail: [email protected]
Website: www.remington-products.com.au
Spectrum Brands new Zealand Limited
Building C, Ground Floor
600 Great South Road,
Greenlane, Auckland 1051 New Zealand
Customer service in New Zealand: 0800 736 776
E-mail: [email protected]
Website: www.remington-products.com.au
REMInGTOn SERVICE HOTLInE
Australia 1800 623 118 (toll free)
New Zealand 0800 736 776 (toll free)
AUTHORISEd REPAIR CEnTRES
Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trademark of Spectrum Brands, Inc. (SBI), or one of its subsidiaries
Manufactured to Spectrum Brands specifications in the PRC
© 2012 SBI
Rev.05/12
Part No. T22-0000311
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
TOOLS OF THE TRADE
FOIL SHAVER
This product is not suitable to use in a bath or shower.
The shaver conforms to radio frequency
interference requirements.
Any product purchased and used commercially
carries a limited 90 Day Warranty.
10
9
F3700AU_IFU_FA_170712.indd 1-7
17/07/12 11:42 AM
