9
USING THE EDGEStyler
The EDGEStyler
tool is used to guide your trimmer to create a symetrical, defined edge to
your beard.
NECK LINE (fig. F)
Hold the appropriate curved side of the tool underneath your jaw and run your trimmer
along it for a clean edge. Repeat on the other side then even up the remaining V left
under the chin freehand.
CHEEK (fig. G)
Hold the appropriate curved side of the tool against the cheek and run your trimmer
along it for a clean edge. Repeat on the other side of your face.
SIDEBURN (fig. H)
Use the straight edge of the tool against the sideburn for perfect, straight edges.
MOUSTACHE (fig. J)
Use the curved edge of the tool to sculpt the moustache area.
CLEANING AND MAINTENANCE
•
To ensure long lasting performance clean after each use.
•
Ensure the appliance is switched off and unplugged from the mains.
•
Always store the attachment guide comb on the trimmer blade.
•
Do not use harsh or corrosive cleaners on the unit or blades.
•
To clean the unit, wipe with a damp cloth and dry immediately.
•
Wash the removable blade cartridge under a running tap to remove any hair
clippings.
•
We recommend that you add a couple of drops of oil to the blades every so often.
BATTERY REMOVAL
•
The battery must be removed from the appliance before it is scrapped.
•
The appliance must be disconnected from the supply mains when removing the
battery.
•
Ensure the trimmer is discharged of all power.
•
Remove the comb attachment.
•
Detach the blade head.
•
Remove the head clip using a screw driver.
•
Pry apart the top and bottom housing.
•
Unscrew the two screws on the circuit board.
•
Remove the upper circuit board.
•
Disconnect the battery from the low circuit board.
•
Dispose of the batteries safely.
Summary of Contents for Crafter Beard MB4051
Page 2: ...2 e f g i j k l m h A h B h C ...
Page 3: ...3 h E F H J G h D ...
