8
CLIPPING
1. Lift this section of hair, guide into the adjustable comb and run the clipper through.
Go over a couple of times.
2. Now it’s time to blend. Lower the grade setting on your trimmer to move onto the
next higher section of hair (eg. grade 4 to 3). Go slightly higher than previous
section working upwards (fig. B). Again, place hair into the comb and run the clipper
through.
3. Repeat process (eg. grade 3 to 2) - this is fading. Keep moving the process upwards
until you match the grade number on the sides of your head (fig. C).
4. Trim any protruding hairs with the scissors.
5. Brush your beard through with the beard brush.
6. Add your choice of beard oil/beard wax to your beard.
TRIMMING EDGE OF SIDEBURNS
•
Hold the trimmer with the trimmer blade facing you.
•
Start with edge of sideburn and with the trimmer blades resting lightly against your
skin, use motions towards edge of sideburn line to trim to desired locations in facial
area.
•
Shape as desired.
TRIMMING THE NAPE OF YOUR NECK
•
You will need a hand mirror for this operation if performing it alone.
•
Use your fingers to lift the hair at the base of your head up off the neck. Your index
finger should be covering the roots of the hairs you are lifting to prevent accidental
removal by trimmer.
•
Using your other hand, hold the trimmer to the base of your neck with the cutting
unit facing up, and move the trimmer up the length of the neck until it touches your
finger covering the hair roots at the base of your head.
•
Be sure to move the unit slowly when performing this operation and to keep the hair
roots at the base of your head out of the way of the trimmer.
TIPS FOR BEST RESULTS
•
Beard, moustache and sideburn hairs should be dry.
•
Always brush your beard before beginning to trim, shape or style it.
•
Avoid using lotions before using your trimmer.
•
If you are trimming for the first time start with the maximum comb length setting.
ATTACHING AND REMOVING THE BLADE
•
To remove the blade press the release button found at the top of the trimmer where
it meets the back of the blade head and push the blade cartridge upwards and away
from the trimmer.
•
To attach a blade, snap the desired cartridge in place until it clicks.
Summary of Contents for Crafter Beard MB4051
Page 2: ...2 e f g i j k l m h A h B h C ...
Page 3: ...3 h E F H J G h D ...
