7
4. Lower the end of the bib over a waste bin and gently shake out the hair clippings
using the bib as a chute to guide the clippings into the bin.
5. Release the suction hooks by rotating the hook upwards. Carefully pull the hook off
the surface it was fixed to.
TO THIN AND TAPER THE BEARD/MOUSTACHE
•
Turn the unit on.
•
Place the flat top of the trimmer comb against the skin.
•
Slowly slide the trimmer through the hair. Repeat from different directions as
necessary.
•
If hair builds up in the trimmer comb during the trimming process, switch the unit
off, pull off the comb and brush off.
DETAILING
•
To create sharp lines around your beard, press the pop-up trimmer release button.
•
Start with the edge of the beard/moustache line and gently lower the trimmer
blade onto your skin. Use motions towards the edge of the beard/moustache line to
trim to the desired locations in the facial area and away from beard in neck area.
TRIMMING AND STYLING LONGER BEARDS
•
To take out volume from your beard or if you want to take down the length
significantly, select your desired length setting on the XL comb (please see the
table for trimming length settings). Place the flat top of the trimmer comb against
the skin. Slowly slide through the hair. Repeat from different
directions as necessary.
•
If hair builds up in the trimmer comb during the trimming process, switch the unit
off, pull off the comb and brush the hair off.
HOW TO BLEND/TAPER YOUR BEARD
•
Tapering is when you fade the length of your beard from shorter sideburns to a
longer beard. This is how you can truly style your beard based on different lengths
and shapes.
1. Adjust the comb to your selected grade.
2. Grade settings and the respective trimming lengths the beard kit offers can be seen
in the table. You will either need to use the short length adjustable comb or the XL
adjustable comb depending on the grade you require. If you don’t know, you can
start at a longer trimming setting and work up towards your hairline, lowering the
grade number as you go.
3. Beard hairs sit on your face much lower than at the root compared to stubble.
Therefore, use a comb to lift up the hair you want to remove and identify where the
root is. This section of hair should be located at the middle of your ear (fig. A).
•
Start grading your beard here, upwards. Don’t start clipping too low or you are
going to be taking away supporting hairs lower down.
Summary of Contents for Crafter Beard MB4051
Page 2: ...2 e f g i j k l m h A h B h C ...
Page 3: ...3 h E F H J G h D ...
