Remii WM-55-XS, Installation And Operation Instruction Manual, Page: 6 / 24

UNPACKING AND TESTIN
Carefully remove the appliance f
Prior to installing the appliance, t
the power supply cord into a 120
Test all aspects of its operation (
components are operating correc
As with most electronic devices
temperatures between 5
℃ (41 ℉
fireplace to reach room temperat
NOTE: There may be trace of
harmless, normal and will neve
GROUNDING APPLIANCE
This appliance is for use on 12
shown in (C) is available for
receptacles. The green ground
permanent ground such as a pro
three-slot grounded receptacle is
To disconnect appliance, turn co
LOCATING THE FIREPLAC
Plan where to locate and frame t
install the fireplace. Before instal
1. Where the fireplace is locate
2. Consider a location where t
windows or doors.
3.
A 15 ampere, 120 Volt, 60
location. Preferably a dedica
to trip of fuses to blow.
6
NG APPLIANCE
from the box.
test to make sure the appliance operates
0 Volt grounded outlet.
(manual switches, remote and heater) to
ctly.
s, your new electric fireplace has been d
℉ ) and 3 5 ℃ (95 ℉ ). During the cold w
ture before turning it on.
f odor during the first few minutes o
er occur again.
20 Volts. The cord has a plug as shown
r connecting three-blade grounding ty
ing lug extending from the adapter mu
operly grounded outlet box. The adapter s
s available.
ontrols to off, then remove plug from outle
CE
the fireplace. This will save time and mon
llation consider the following:
ed must allow for wall and ceiling clearanc
the fireplace screen will not be exposed
Hz branch circuit with proper ground m
ated branch circuit should be provided to
properly by plugging
make sure all
designed to operate at
winter months, allow the
of initial use. This is
n in (A). An adapter as
ype plugs to two-slot
ust be connected to a
should not be used if a
et.
ney later when you
ces
d to direct sunlight from
must be available at the
o avoid circuit breakers