Dos and Don’ts
Do Not:
•
Over tighten the union connections as this can split the fibre washer.
•
Remove the clips at the top of the unit holding the rail connectors in place.
•
Get any solder, flux or dirt inside the unit or into the ball valves or connections.
•
Flush and/or pressure test the network while the unit is connected to it.
•
Flush the primary or secondary side through the unit.
•
Use flux or chemicals which could harm parts made of stainless steel, brass, copper or
fibre washers
Do:
• Always use two tools to block the adjacent part when tightening a union nut connection
so that other connections are not affected and accidentally loosened.
• Ensure all connections are leak free after installation
4