Reliance FXM920, Installation And Operating Instrucitons

Page: 9 / 32

3.3. Chair Top
3.3.1. Positioning The Chair Back
• The chair back may be reclined or raised by actuating the
release handle and pushing downward or gently pulling
upward on the release handle (Figure 4).
• If the chair is equipped with an articulating leg rest, the
foot-step and apron will rise when the back is reclined.
3.4. Revolving/Rotation
3.4.1. The chair upper structure may be revolved 350°,
with a built-in stop to prevent continuous rotation. The lock
for revolving is controlled by a hand lever with chrome plated
knob located below the seat at the center and on either side.
Push the lever in the direction of footrest to apply the lock
and in opposite direction to release the lock.
NOTE:
The lock must be applied each time before
the chair is used. 30 lbs locking force is necessary
to lock chair for one working day. Vibration of chair
during transportation or moving on rough surface
will release the lock.
NOTE: La serrure doit être appliquée chaque
fois avant que la chaise soit employée. 30
livres fermant la force à clef est nécessaire
pour fermer la chaise à clef pour un jour
ouvrable. La vibration de la chaise pendant
le transport ou se déplacer sur la surface
RELEASE HANDLE
FIGURE 4
Release Lever.
3.5. Arm Movement
3.5.1. The chair arms may be raised to provide better
access to the patient or to permit entrance to or exit from
the chair.
3.5.2. The movements of both arms are identical and
completely independent of each other.
3.5.3. To raise an arm, push rearward on the middle joint
of the arm support link while raising upward on the arm. A
stop limits upward motion of the arm to a point parallel to
the plane of the back. Lowering the arm automatically locks
it in place against vertical motion in either direction.
3.6. Footrest
3.6.1. The footrest may be retracted by lifting near its outer
edge. When retracted, the footrest stays in place.
3.7. Headrest
3.7.1. The No. 26 headrest is the standard headrest for
the Model FXM920 Chair.
WARNING-
IF THE NO. 26 HEADREST
RECEIVES A IMPACT OR STRIKES AN OBJECT
WITH FORCE CONTACT RELIANCE® TECH
SERVICE IMMEDIATELY.
AVERTISSANT-
SI L’APPUI-TÊTE DU NUMÉRO
26 REÇOIT UN CHOC OU HEURTE UN
OBJET AVEC LE SERVICE DE TECHNOLOGIE
D U C O N TA C T R E L I A N C E ® D E F O R C E
IMMÉDIATEMENT.
3.7.2. Operation-No. 26 Headrest
3.7.2.1. The No. 26 headrest is designed so it can be
operated with just one hand. To unlock, squeeze the clear
plastic actuator into lock housing. This will allow both pivots
of the articulating arm to rotate so the headrest can be
moved to a new desired position. Once in the new position,
release the actuator. Make sure the actuator expands to its
original position fully exposing the black dot on handle to
insure a positive lock. The headrest pad is free to rotate at
all times. (See Figure 5).
IN-FXM920
9