Reliance FXM920, Installation And Operating Instrucitons

Page: 10 / 32

3.7.3. Adjustment-No.26 Headrest
3.7.3.1. There are three adjustments provided on the No.
26 headrest. The fi rst is the tension on the pad rotation.
By tightening the two hex acorn nuts on the pad pivots with
a 3/8” open end wrench, the tension will be increased.
To adjust the drag on the pivots of the articulating arm,
loosen the set screw in the center of the pivot with a 3/32”
hexagon key wrench (Figure 5, item 1). Next, tighten the
pivot screw on the other side of the pivot, with a 1/8”
hexagon key wrench. Now, retighten the set screw to retain
the pivot screw at the new adjustment. Either pivot may be
adjusted.
FIGURE 5
3.7.3.2. The third adjustment is for proper clearance of the
block dot to indicate that the headrest is properly locked.
If the dot does not fully clear the lock housing when the
headrest is locked securely, turn the set screw located at the
top of the lock housing (Figure 5, item 2) counterclockwise
until the dot on the actuator is fully exposed.
ACORN NUTS
BLACK DOT
ACTUATOR
2
1
4.0 LOCATING AND REPLACING FUSES
WARNING-
DISCONNECT CHAIR BASE FROM
AC POWER INPUT BEFORE PROCEEDING
W I T H E L E C T R I C A L I N S P E C T I O N S O R
MAINTENANCE.
AVERTISSANT-
DÉMONTEZ LA BASE DE
PRÉSIDENCE DU COURANT ALTERNATIF ENTRÉ
AVANT DE PROCÉDER AUX INSPECTIONS OU
À L’ENTRETIEN ÉLECTRIQUES.
CAUTION-
Replace fuse(s) as marked. All
fuses must be replaced with a fuse of the same
size and rating. Refer to the Wiring Diagram
on page 28.
ATTENTION -
changez le détonateur (s)
comme marqué. Tous les détonateurs doivent
être changés avec un détonateur de la même
taille et de la notation. Référez le diagramme
de câblage à la page 28.
The chair contain two fuses located inside the AC Input
Module in the Base Assembly.

IN-FXM920 10