www.relinc.com
iREL
Systems
18
Chapter 5 – Preventive Maintenance
Introduction
Preventive maintenance (PM) is essential for the proper operation of the Line.
Elements of an effective PM program include documentation, verification of proper
operation, routine maintenance, inspection, spare/replacement parts, and electrical
maintenance.
CAUTION!
Do not attempt to perform any maintenance on equipment until all safety instruction
have been reviewed and all power sources are locked out as described in Chapter 3 -
Safety.
Routine Maintenance
Lubrication of Bearings
All of the mounted bearings require grease lubrication.
Gear Box Oil
See manufactures recommendations regarding changing oil in the drive motor
gearbox.
UHMW Wear Strips, on conveyors
The wear strips on each conveyor section should be inspected after every year of
operation. Replace the wear strip if it shows signs of excessive wear.
Summary of Contents for iREL Systems
