INSTRUCTIONS FOR EMERGENCY LIGHTING FIXTURE
INSTRUCTIONS FOR EMERGENCY LIGHTING FIXTURE
INSTRUCTIONS FOR EMERGENCY LIGHTING FIXTURE
INSTRUCTIONS FOR EMERGENCY LIGHTING FIXTURE R
R
R
R----1SDT
1SDT
1SDT
1SDT
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT::::
Battery in this unit may not be full
charged after electricity is connected to unit, let battery charge
up for at least 24 hours. Then normal operation of this unit
should take effect. To check, press the “TEST” button. The
light inside the unit should turn on.
IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS
:
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Do not use outdoors.
2. Equipment should be mounted in locations at heights where it will not be subject to tampering by
unauthorized personnel.
3. Do not mount near gas or electric heaters.
4. The use of accessory equipment is not recommend by the manufacturer may cause an unsafe condition.
5. Do not use this equipment of other than its intended use.
6. Servicing of this equipment should be performed by qualified personnel.
7. Disconnect AC power before servicing.
SAVE THE ABOVE INSTRUCTIONS
FLEXIBLE CONDUIT ONLY
INSTALLATION (J
INSTALLATION (J
INSTALLATION (J
INSTALLATION (J----BOX MOUNTING)
BOX MOUNTING)
BOX MOUNTING)
BOX MOUNTING)::::
1. Feed fixture leads through back plate and connect AC power supply (Fig. A).
2. Connect wires through J-Box. Mount back plate on J-Box and secure with screws.
3. Connect battery only after continuous AC power can be provided to the unit (Fig. B).
4. Align snaps and push housing directly onto main bottom case (Fig. C).Apply continuous AC power and
press “TEST” button to check light.
INSTALLATION (CONDUIT)
INSTALLATION (CONDUIT)
INSTALLATION (CONDUIT)
INSTALLATION (CONDUIT)::::
1. Secure back plate to wall surface. Route wires through hole in conduit flange and make conduit connection.
2. Connect battery only after continuous AC power can be provided to the unit (Fig. B).
3. Align snaps and push housing directly onto back plate (Fig. C). Apply continuous AC power and press
“TEST” button to check light.
