Pg. 26
Doc ID: 191-6305A
Doc Rev: 101818
5. Push the turn pin in far enough to clear the base, then turn
90° and release the pin. The pin should sit almost flush
with the EXP base.
6. Flip the EXP friction disk over, and repeat on the other
side depending on engagement preference.
If you disassemble the EXP, the Teflon pads may fall out or
be stuck to the ramp surfaces of the EXP bases. Take care to
ensure all pads are correctly placed into wedge pockets
using gentle pressure to avoid damage to the pad surfaces
before reassembling the EXP. Properly seated pads will be
secured in place once the EXP is reassembled. Operating the
clutch without the pads in place will cause part damage or
failure.
