Pg. 14
Doc ID: 191-7008001A
Doc Rev: 080720
7. Install the Rekluse pressure plate springs, followed by the
screw sleeves and socket head cap screws.
Do not reuse the OE springs, washers, or bolts!
Note:
If two different spring colors are provided with your kit, be
sure to alternate the springs by color in every other pocket to
keep even pressure on the clutch.
*Heavier springs options are available from Rekluse if desired*
8. Use a torque wrench and socket to torque the cap screws by
lightly tightening the screws in small increments. Torque the
cap screws to
9 ft-lb (12 N-m).
9. With the pressure plate screws torqued, pull the clutch lever a
few times to ensure proper function of the hydraulic clutch
system. If everything functions well, move on to the next
section.
Note:
If you feel abnormal resistance when pulling clutch lever
(i.e. it does not travel all the way to the handlebar) then it is
likely that the OE throwout rod has worn enough to change the
optimal spacing of the slave cylinder piston. Remove the
circlip from the OE throwout assembly and install the included
throwout washer between the throwout assembly and the
pressure plate. This will return the spacing to normal.
