63
4
Work unit carrier arms (Sensors R25 and R35)
Machine and tractor in an extended position and on a flat surface.
4.1
Boom in 90° position (= Transport position):
4.1.1
IMPORTANT:
Hoist for lifting work units [R23 and R33] must be fully excavated.
Button cylinder retract button press and hold "F2" until the beep sounds.
4.1.2
Carrier arm cylinder using cylinder extension button "F3" lower working units
gradually
on
both
sides to 45 ° and then lower
both
sides to 0 ° (= touch down on
the ground).
When the "0 ° position" is reached, press the
OK button
"F1" until the beep
sounds. (
Should possibly be carried out again after complete calibration after the
machine has been brought into the floating position by means of "!")
4.2
Boom in 0 ° position (= working position, on level surface) and four-wheel chassis in floating
position (button "!"):
4.2.1
Press and hold the
OK
button until the beep sounds
4.2.2
IMPORTANT:
Hoist for lifting work units [R23 and R33] fully raised, carriages [R24
and R34] fully extended and top link cylinder fully extended (can only be operated
in manual mode). Button Press cylinder retract button "F2" until
both
extension
arms [R25 and R35] are at approx. 60 °. Swing
one
boom further to 90 ° (=
transport position) and keep the button pressed until you hear a beep. Then
continue to swing the
second
boom 90 ° and hold down the button until you hear
a beep.
Hydraulic plans & electrical plans are available on request.
