49
Adjust the tractor lift so that the PTO shaft is horizontal. Lower work units on level ground.
Now check the distance between the pick-ups as shown in the picture.
The factory setting is about 2-3cm.
The lifting linkage of the working units must be lowered completely under pressure - no
floating position permitted!
The wishbone cylinders pull the working
Fine adjustment hoist strut for use in straw
units inwards..
(cereals, maize).
8.
Field working
Before bringing the machine into working position, the following points must be observed:
•
Make sure that there are no persons in the swivelling range of the machine.
•
If necessary, refer all persons from the swivel range.
The machine is equipped with a steering device to enable:
•
The machine can follow the tractor track.
•
Turning at the end of the field is easier and the machine is aligned more quickly back straight,
as a machine without steering device.
•
Better to drive in hard-to-reach field plots.
The attachment allows a turning angle of 90 degrees between tractor and machine
to the right or left. The angle depends on the external width of the tractor. To
protect the steering system, never try to force a larger steering angle.
Forward speed
Basically, the machine can be driven as fast as mowing before. However, the speed should always be
adapted to the working conditions.
