62
Attachment:
(1)
Calibrating the angle sensors:
If an angle sensor has to be replaced due to damage, the sensor must be
recalibrated.
In the event that the operator terminal is damaged and needs to be replaced, all
angle sensors must be recalibrated. This allows the new terminal to communicate
properly with the machine.
R9
–
Instructions for calibrating the sensors
IMPORTANT: Only trained personnel are allowed to calibrate sensors.
Recalibrate sensors only when a sensor has been replaced, a sensor has been moved by mechanical
manipulation, or a new operator terminal is being used.
1.
Switch from Work mode to SET mode by pressing the ESC key.
2.
Switch to "SET" mode at the terminal by pressing the "F2" key for a long time. List of all
sensors to be calibrated appears.
3.
Select sensors to be calibrated using the up and down arrow keys ("F2" and "F3").
4.
Press the pencil key "F1" to change to edit mode.
Calibrating sensors:
1. Hoist for lifting the working units in the headland (sensors R23 and R33):
1.1
Raise the working units completely by means of the control unit on the tractor, then
hold down the cylinder extension button "F3" until the signal sounds.
1.2
Using the control unit on the tractor, lower the working units completely, then press
the cylinder retract button "F2" until the signal sounds
2
Carriage for lateral displacement of the working units (sensors R24 and R34):
2.1
Only operate during slow driving or on slippery surfaces.
2.2
Press and hold the cylinder extension button "F3" until the carriages have been
completely extended and a signal tone sounds.
2.3
Press and hold the cylinder retract button "F2" until the carriages have been fully
retracted and a signal tone sounds.
3
Rotor (rotor symbols for sensors R65 and R75):
Lower both work units on level ground (sensors R23 and R33).
3.1
Press and hold the cylinder extension button "F3" until the rotor has lifted
completely and a signal tone sounds
3.2
Press and hold the cylinder retract button "F2" until the rotor has been lowered
completely and the signal tone sounds.
