MWS 9-5e.p65 Page 30
MWS 9-5 Manual
erstellt am 30.05.2012 von DO
REINHARDT
System- und Messelectronic GmbH
Fax: 08196/7005 and 1414 email:
Web:
www.reinhardt-wetterstationen.de
Transmitting linearisation data:
'!' 'L' <SENSORNUMBER> ',' <INDEX : 1..6> ','
'F' <VOLTAGE(mV)> <#13>
'!' 'L' <SENSORNUMBER> ',' <INDEX : 1..6> ','
'
W' <ANALOGVALUE> <#13>
Setting the general averaging size
'!' 'MX' <#13> ;
1 <= X <= 255 ; X = 0 : averaging off
Setting local altitude for correct display of barometric pressure
'!' 'O' <LOCALALTITUDE(m)> <#13>
Resetting windpeak and average wind
(only if storage interval is set to 0 (deactivated)
'!' 'P' <#13>
Setting the compression quality
'!' 'QX' <#13>;
2 <= X <= 255 ;
X = 0 : highest compression, (1 complete set/ day)
X = 1 : every record is complete (compression off)
X = 2 : every 2nd record is complete
X = 3 : every 3rd record is complete ...
Resetting the rain/precipitation measurement
'!' 'R' <X> <#13>
X means every hour on the hour for rain reset, if storage interval > 0
'!' 'R' <#13>
Resets rain to 0, if storage interval = 0
Turning on / off the interface (Protocol-Select)
NOTE: These settings are very complicated and sensitive.
In case of wrong operation, the sensor can be obstructed irreparably.
'!' 'SX' <#13>
Suppresses the data output to the interface
X is the decimal value of the following binary list for the various protocols.
Binary list of the protocol-parameter for X.
X (binary) =
xxxxxx00b : RS232 - MWS 9-5 transmits a data record every 2 sec
xxxxxx01b : RS422 - MWS 9-5 transmits a data record every 2 sec
xxxxxx10b : RS485 - MWS 9-5 is addressed and transmits on request
xxxxxx11b : Profibus - MWS 9-5 is addressed and transmits on request
xxxxx1xxb : MWS 9-5 transmits on request only (RS232 + RS422)
xxxx1xxxb : MWS 9-5 transmits when writing on datalogger and on request
xxx0xxxxb : Output in ASCII-format and German date
xxx1xxxxb : Output in ASCII-format and American date
xx1xxxxxb : Output in compressed format
By combination (addition) of single binary values, you can combine the parameters.
Example for MWS9-5 with RS422 transmits on request only :
X for RS422 (binary) = xxxxxx01
X for transmits on request (binary) = xxxxx1xx
adds --> = xxxxx101 --> Decimal = 5 --> !S5<#10>
CAUTION: With RS485 after the ! or ? always the device address must be inserted! Other ways
the command won't be accepted! (Standard@ = 1)
