1 INSTALLATION AND SETUP
5
ALPIN100 Manual © Copyright 2008 by Reimesch Kommunikationssysteme GmbH
1.
INSTALLATION AND SETUP
1.1.
PACKAGE
When the amplifier is delivered to you it is packed in a cardboard box with styropor inlays.
Please handle the package with care. In case of damage you may need it for the ALPIN 100 to
be transported back safely.
1.2.
CONNECTIONS
POWER CABLE
The green-yellow wire is a chassis safety ground and
must always
be connected to the safety
ground of the AC mains. (the AC-PLUG will not be supplied with the amplifier) The blue
and brown wires are the powerleads. Please take care that the groundlead be cut a bit longer
than the power leads (blue and brown) at installing the plug.
GND
Connect the ground stud of the amplifier on the rear panel to the grounding system. The wire
used should be of large diameter and run to a good earth ground.
RF INPUT AND OUTPUT
Use a 50 Ohm coax cable with PL259 plugs. Take RG 213 or any better antenna cable and
have a look on the antenna section on page no. 9.
CONTROL CONNECTIONS
Use a shielded cable with a Phono (RCA) connector from the Relay socket on the rear panel
to the transceiver socket, providing "ground on transmit".
