Attach hoists to the lifting point on the trolley
only, making sure it is attached in a way that
does not expose the user to danger by the
hoist, chain or load.
When lifting, keep the load low to the
ground.
Only raise and lower loads when castor brakes
are engaged.
Do not allow loads to swing.
To avoid side pull, lowering and lifting should
only be carried out when the load chain forms
a straight and vertical line between the load
and lifting attachment point on the trolley. If a
vertical lift is not possible you must ensure that
the load is within the footprint of the Gantry
A-Frames (refer to figure A).
Correct Operation
We recommend the use of load-sensing or
overload protection devices on all lifts.
The product should not be moved under load
except when a competent person or authority
has approved a risk assessment and method
statement.
The risk assessment and method statement
must take into account any factors that might
apply additional loading to the system during
lifting operations.
Take care when transporting and storing the
system to avoid damage.
Warning
The equipment should not be used outside
of its limitations, or for any purpose other than
that for which it is intended.
Do not lift or transport loads while personnel
are in the danger zone.
Do not allow personnel to pass under a
suspended load.
Never leave a suspended load unattended.
Do not start moving the load along the beam
until you have checked that it has been
attached correctly.
When moving a loaded trolley along
the beam, move the load steadily and in
a controlled manner and avoid sudden
movements.
Don’t allow the load to hit the system frame.
When winching, only use one winch with each
sheave and make sure they never cross paths
with each other.
Be aware of any adverse weather conditions
such as strong or gusty winds which could
impose additional horizontal loads and affect
the stability of the structure. Stop using if
weather is impacting on lifting, and either
disassemble the gantry or tie it to a rigid
structure to ensure it can’t overturn.
Be aware of hazards when setting up/folding
down, such as trapping fingers in rotating
parts.
Note: The Rapide Tall Systems are fitted with
trolley stops on the beam (see below). This
is a safety feature and must always be in
place before use. If beam length adjustment
is required, stops must be repositioned
accordingly.
A