7
Use as a Fall Protection Anchor
This section must not be read in isolation from
all other sections of this manual. Read the whole
manual before using this product.
Fall arrest: This product is tested and conforms to
the requirements of ANSI Z359.18-2017 type D for
fall arrest protection for single or multiple users
depending on the configuration of the product.
The Product can be used as part of a personal fall
protection system that meets the requirements of
ANSI Z359.18, OSHA 1910 subpart I and 1926.502
subpart M. When being used for fall arrest, the
operator must use a body harness and a shock
absorber that complies with the relevant national
standards and regulations and that limits the
maximum allowed force (MAF) to 8kN.
Users may be attached to the system via a
traveling trolley (which may also be locked in
place) or via a fall protection device mounted
to the side cheek plate of the A frame, which
is subsequently deviated through a pulley and
sheave carrier. Only one person should be
attached to each trolley in accordance with the
notified capacity. Each personnel lift must be
properly planned, and all weights clearly known
along with a clear understanding of the capacity
and constraints of all personal fall arrest system
components.
The capabilities stated in the table below apply to
standard range systems only. If unsure about your
system consult serial labels, information filled in on
page 27 or consult your supplier. Custom versions
of the system are available tailored to specific
lifting needs. These versions are designated with
a ‘C’ at the end the product number on the serial
label attached to each A-frame and beam.
This product has different ratings depending on
the application as detailed in the table below:
Additional Notes for Correct
Operation
The anchorage must always be above the users
head to prevent dangerous free falls
Always carry out pre-use checks before using
this equipment. It is advised to use a buddy
system and inspection must be by a competent
person.
The fall arrest device must only be attached to
the lifting point on the trolley or the designated
location on the cheek plate or upright. (see
product images and set up instructions).
Never walk away from the footprint of the
product or move outside designated safe
zones whilst connected to it where there is a
risk of a fall (refer to figure B). Ensure that the
operating area is within the footprint of the
system before beginning work.
When using the product as a fall arrest anchor
ensure there is adequate fall clearance
when working at height (refer to figure C). A
competent person should calculate this taking
into account all of the components of the
personal fall arrest system and allowing a safety
margin.
*Only Applicable to the product being used in accordance with ANSI
Z359.18. The product can support more users in Fall arrest if used in
accordance with OSHA 1910 Subpart I or 1926 Subpart M. Please contact
REID Lifting for further details.
Application
Capacity
1100
2200
4400
6600
Fall Arrest*
2
persons
2
persons
2
persons
2
persons
C
PORTA
GANTRY
1100-6600
Fall Protection Applications
B
