Tel: +44 (0)1291 620796 www.reidlifting.com
specialist workshop that uses original spare parts.
It is recommended that once inspected the device is
marked with the date of next inspection.
Inspections are instigated by the user.
If detailed information is required on inspection
and test criteria, please refer to your supplier’s
technical department.
Please refer to page 19 for the equipment
Inspection Record.
If using the davit in explosive atmospheres see
additional section titled ATEX - page 9.
Maintenance/Repair
In order to ensure correct operation, not only the
operating instructions, but also the conditions for
inspection and maintenance must be complied with.
If defects are found
stop
using the davit immediately.
No alterations or additions to the equipment
should be made without the written consent of the
manufacturer. Any repair shall only be carried out in
accordance with the manufacturer’s procedures.
It is recommended to maintain the equipment in a
clean and dry manner. Cleaning is suggested using a
sponge or cloth with warm, soapy water (using diluted
domestic washing up liquid), rinsing and allowing to dry.
The majority of the structure is constructed from
aluminium with steel fasteners; non-metallic parts are
constructed from acetal co-polymers, polyethylene
and polyester.
Storage and Transportation
The
PORTA
-DAVIT 500 and its accessories are to be
stored and transported in the bags provided.
When transporting the components the user must
take note of the manual handling considerations.
SOCKETS
The
PORTA-
DAVIT 500 structure needs to be anchored
to a surface/foundation capable of withstanding the
applicable loading. The davit can be supplied with one
of the sockets specified below
(only sockets supplied
by REID Lifting are approved to be used with the
PORTA
-DAVIT 500):
Top
Mount
Side
Mount
Bridge
Mount
•
The
Top Mount
socket is for use on flat horizontal
surfaces. It can be installed onto concrete using
resin bonded anchors or into steel work using bolts
•
The
Side Mount
socket can be installed using resin
bonded anchors or mechanical anchors
•
The
Bridge Mount
socket is for mounting into steel
work and walkways
•
The
Cast & Resin Bonded
sockets can be cast
into new concrete or resin bonded into existing
concrete
Socket Installation
Depending upon the socket type there are multiple
ways that installation can be achieved. When using
bolts they are to be minimum grade 8.8 BZP or if
stainless, grade A4 or equivalent.
When installing the socket it is important to
ensure that the top face is as level as possible, with
installation being not more than 3 degrees misaligned
from the horizontal.
Socket installation should only be carried out by a
competent person. If specifying the anchors, resin,
fasteners or any combination of the afore-mentioned,
it is essential that the competent person is of ability
to specify an installation that is safe for use. If in any
doubt about the calculation of loads contact your
REID Lifting representative.
Cast & Resin
Bonded