REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual BASIC LIGHT 19
SERVICE MANUAL
SEAT DEPTH
Now, unfold the wheelchair and, according to the length of the armrest, see the hole of the three through which you will fix the
armrest’s
front support.
It is possible, like in this case, you have to fix the support using the same hole where it is present the bolt that fixes the frame. Just remove
that bolt and fix it using the next hole. Now you can fix the support. The stability of the frame is not altered.
If the wheelchair is not equipped with Flip-up armrest, skip this step and read the note at the end of this sheet.
Repeat the same operation on the other side of the wheelchair until this step.
PATELLA
With seat depth 40 cm (therefore without spacers between crossbar and rear frame) the gap between the seat canvas and the backrest tube
is small, on the other hand, that gap increases by 2.5 or 5 cm with seat depth 42.5 or 45 cm.
However, the vanity flap connecting the seat canvas to backrest upholstery covers that gap.
Notes:
if the wheelchair is equipped with
Desk armrests
, the support
for this armrest is fixed using two of the three holes here indicated.
If fixed to holes 1 and 2, there is never interference.
If fixed to holes 2 and 3 and the seat depth becomes 40 cm (with no
spacers), the inner tube reaches over the hole 3. The diameter of the
inner tube holes is 6 mm, whereas the diameter of the hole to fix the
armrest support is 8 mm.
Now you can decide whether to move the support to hole 2 and 3 or
enlarge the hole of the inner tube. In both cases, you have to remove
the support.
If the wheelchair is equipped with
tubular armrests
, the mudguard is
fixed to the backrest support and to the frame with the bolt 4. To per-
form the seat depth adjustment, remove the mudguard. When you re-
mounted, the fixing points will be the same.
