REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual BASIC LIGHT 7
SERVICE MANUAL
SETTING (point of balance)
Slide the plate
P
until aligning its holes to the frame’s.
Should sliding be difficult, lubricate the involved parts.
Insert and screw the four bolts
V
, for each bolt, with one finger, hold the corre-
sponding nut within the housing of the plate.
Repeat the same operation for both sides of the wheelchair.
The standard and prudential setting do not show any issue.
In case of active setting (fixing holes 1 and 2), you can position the plate only if you
first remove the washer
R
of the crossbar tube support
S
fixing unit. In fact, this
washer prevents the plate from sliding to the alignment of the holes.
Partly fold the wheelchair and flip the armrest back. Unscrew the bolt
T
while hold-
ing the nut
D
. remove the nut, remove the washer
R
and leave the bolt
T
without
nut.
Move the plate until aligning the holes and insert the four bolts
V
.
Mount the nut
D
aligning one of its faces to the plate.
Screw the bolt
T
while holding the nut
D
.
If there is not enough room for the nut
D
(due to unfavourable tolerance), it is nec-
essary to slightly widen the holes for the fixing bolt
T
.
Check and, if necessary, adjust the fork angle.
See sheet “fork angle adjustment”.
Adjust the brakes.
See sheet “brake adjustment”.
Prudential setting.
Plate position:
holes 3 and 4.
1 2 3 4
P
V
You can adjust the rear wheel
plate
P
in three different positions:
prudential, standard and active.
The standard position is in the
middle as in the picture on the
side.
The plate is fixed on holes 2 and 3,
while holes 1 and 4 are visible.
Screw off the four bolts
V
–
the
corresponding nuts are built in the
plate, therefore, you do not need
the spanner.
