Regency Freestanding Woodstove
10
Horizontal Installation
Standard Ceiling Installation
support to a minimum height of 3 feet (.9m)
above the roof penetration, or 2 feet (.6m)
above any point within 10 feet (3m) meas-
ured horizontally. There must be at least 3
feet (.9m) of chimney above the roof level.
Note: Increasing the chimney height above
this minimum level will sometimes
help your unit to “breathe” better
by allowing a greater draft to be
created. This greater draft can de-
crease problems such as, diffi cult
start-ups, back-smoking when door
is open, and dirty glass. It might
be suffi cient to initially try with the
minimum required height, and then
if problems do arise add additional
height at a later date.
4)
Slide the roof
fl
ashing over your chimney
and seal the
fl
ashing to the roof with roo
fi
ng
INSTALLATION
1)
For easier assembly, tip the stove on its
back (onto a soft surface to prevent scratch-
ing).
Hint:
If you have chosen the Ash Drawer
option, remove the ash dump cover plates
before attaching the pedestal. See page 16
"Ashdrawer Kit Installation".
2)
Remove the blanking plate if
a)
you are
not
installing outside combustion
air or
b)
outside air is to be brought in from the
rear
of the stove.
3)
Unscrew the 4 bolts in the under-side of the
stove. Align the holes in the corners of the
pedestal top with the corresponding holes
in the base of the stove. Fasten using a bolt
and washer for each corner.
4)
Push the Regency logo into the two holes in
the front bottom left corner of the pedestal
cover plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.
5)
If not using ash drawer, then cover plate must
be installed. If using ash drawer, then disregard
cover plate.
STEP-BY-STEP
CHIMNEY AND
CONNECTOR
INSTALLATION:
Note: These are a generic set of chimney in-
stallation instructions. Always follow
the manufacturers own instructions
explicitly. Check Table 1 on page 13
for the Minimum Recommended Flue
Heights.
1)
With your location already established, cut
and frame the roof hole. It is recommended
that no ceiling support member be cut for
chimney and support box installation. If it is
necessary to cut them, the members must
be made structurally sound.
2)
Install radiant shield and support from above.
3)
Stack the insulated pipe onto your
fi
nish
Leg and Bottom Shield Assembly
The instructions below apply to the steel leg,
painted cast leg and the gold plated cast leg.
It will be easier to attach the legs to the stove
if the stove is tipped on its back (preferably on
a soft surface to prevent scratching). Ensure to
be extremely careful when tipping stove.
1)
Remove the 4 bolts from underside of the
base of the pedestal and discard. Also
remove cover plate and put to the side.
2)
Line up the heat shield with the bottom of
the unit.
3)
Start threading the bolt and washer (supplied
with the bottom shield) for about 1/4 of the
way through the leg with the washers being
underneath the legs. Ensure that the legs
are properly aligned with heat shield and
tighten the bolts.
4)
Level the stove by adjusting the levelling
bolts in the bottom of each leg.
5)
Reinstall cover plate.
6)
Install logo plate onto heat shield by placing
in 2 holes as shown in diagram.
If you are installing outside combustion air, bend
the tabs out 90 degrees. Pipe fresh air into the
bottom shield by using a minimum 4" duct pipe
with a mesh grill at the outside termination. At-
tach the pipe to the 2 tabs with screws.
