24
Regency PG33NG4-R Gas Inbuilt
installation
Conversion Kit #433-968 for NG to LPG
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT
DO NOT DO THIS CONVERSION !!
1
918-576
12/06/06
PG33-4 / P33-3
1)
Shut off the gas supply and unplug the
power cord.
2)
Carefully remove the glass, logs and
lava rock.
3)
Remove burner.
4)
Remove burner orifi ce with a 1/2"
wrench and discard. Use a wrench to
hold on to the elbow behind the orifi ce.
5)
Reinstall new burner orifi ce stamped #54
and tighten.
6)
Pull out the pilot hood by hand.
11)
Stick the conversion label "This unit has
been converted to LPG" over top of the
serial number decal.
12)
Replace the yellow "NG" label with the
red "LPG" label.
9)
Adjust the burner aeration setting to
12.7mm and re-install the burner.
10)
Open the bottom louver.
15)
Carefully pull out the control box.
16)
Remove the heat shield from the control
box by removing the 2 screws.
Note:
The control box is held in place with
velcro.
screw
module cover
connector
orange connector
wires
control box
heat shield
PG33 Conversion Kit #433-968 from NG to LPG
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
8)
Put in the new LPG orifi ce with the allen
key. Then put back the pilot hood.
13)
Remove the screw from the module and
pull off the module cover.
14)
Pull out the 2 orange wires attached to
the valve, and the connector from the
module.
Burner Orifi ce
Pilot
Hood
Pilot
Hood
removed
7)
Remove the pilot orifi ce with the allen
key.
Conversion Kit Contains:
Qty. Part #
Description
1
904-163
Burner Orifi ce #54
1
904-529
5/32" Allen Key
1
918-590
Label "Converted to LP"
1
908-528
Red "LPG" label
1
910-037
#30 ULPG Pilot Orifi ce
1
918-576
Instruction Sheet
Pilot
Orifi ce
Summary of Contents for Panorama PG33LPG4-R
Page 47: ......
