34
|
P33CE-10 Direct Vent Gas Fireplace
|
34
installation
conVersion froM nG to lp
For P33CE Using SIT 885 NOVA Gas Valve
Each Kit contains one LPG
Conversion Kit
LPG Conversion Kit Contains:
Qty. Part #
Description
1
904-575
Burner Orifice #55
1
918-590
Decal "Converted to
LPG"
1
908-528
Red "LPG" label
1
904-529
5/32" Allen Key
1
910-101
LPG Injector
(Pilot Orifice)
1
911-009
Hi/Lo Conversion LP
1
919-139
Instruction Sheet
Conversion from NG to LPG
for P33CE using SIT 886 NOVA Gas Valve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT
DO NOT DO THIS CONVERSION!!
Installation of the LPG
Conversion Kit:
1.
Shut off the gas supply.
2.
Remove the mesh barrier (see manual)
and glass door.
a)
Release the two hooks from the
bottom of the glass door.
b)
Swing the door out 45 degrees from
the bottom - then lift up and out.
Remove the 2 screws, push Burner
Assembly to the left and lift out.
3.
Remove logs and brick panels if
installed.
4.
Remove the 2 screws holding the Burner
Assembly to the firebox base. Push the
Burner Assembly to the left and lift out.
6.
Unscrew the pilot orifice with the Allen
key and replace with the LPG pilot orifice
in the kit and replace pilot cap.
7.
Remove burner orifice with a 1/2"
wrench and discard. Use another wrench
to hold on to the elbow behind
the orifice.
8.
Reinstall new burner orifice LPG
stamped #55 and tighten.
9.
Remove regulator and discard. Install the
Hi/Lo pressure regulator onto the valve
with 2 screws as shown below.
5.
Undo clip and remove pilot cap to
expose pilot orifice.
Clip
Pilot Cap
Installer Notice:
These instructions must remain
with the appliance.
Burner Orifice
10.
Attach the label “This unit has been
converted to LPG” near or on top of the
serial # decal.
11.
Replace yellow “NG” label with red “LPG”
label.
12.
Reverse step 3 - 1
13.
Check for gas leaks.
14.
Check inlet and outlet pressures.
15.
Check operation of flame control.
919-139b
06.10.14
1
P33E
