40
Regency Horizon HZ54E Gas Fireplace
INSTALLATION
Note:
DO NOT USE 4 AA batteries in the battery pack on the tray - the
DFBC is now powered by the receiver batteries in the wall.
GTM REMOTE INSTALLATION
DFBC
= digital fi replace burner control
1)
Remove the faceplate and glass door to access to DFBC &
battery pack tray.
2)
Lift DFBC and battery pack up and out.
3)
Disconnect connector from battery holder and remove from tray –
(battery holder is attached by Velcro to tray).
4)
Remove the 4 AA batteries if installed, reconnect the connector to the
battery pack and put back onto Velcro strip
5
) Locate the Green and White wires from the DFBC module wire harness;
connect the spade connectors from the receiver wire harness, (TH)
Green to (DFBC) Green and (TH/TP) White to (DFBC) White
6)
Locate the DFC wire from the receiver wire harness and connect to the
DC supply wire from the DFBC.
7)
Remove the hi/lo knob from the valve head, if installed, by removing
2 screws as shown below.
8)
Install the stepper motor in the same location the hi/lo knob was
removed from - with 2 screws as shown below.
