Regency Horizon HZ30E-10 Gas Fireplace
|
45
|
45
installation
919-265
07/10/13
9. Place Left Log (2 ) match pin landing on Log 2 with pin on Log 1, the
bottom should rest on the glass as shown below.
10. Adjust position of Log 4 – log should sit as shown below, 14" from
the left outside of the burner tray.
HZ33CE shown - Left Log (2) positioned to rest on Log 1 and
glass crystals.
HZ33CE shown - Final Install
HZ30E shown - Log 1 in position
HZ30E shown - installing Log 2
2
1
HZ30E INSTALL INSTRUCTIONS:
1. I nstall the log clips on the burner tray - measure 2-1/2" from theoutside
edge of the pilot hood to the outside edge of the log clip.
2. Position Back Log (1) by positioning centre of Log on centre of pilot
hood.Rest Log 1 on log clips.
Each end should rest on the lip of the burner tray – as shown below.
3. Position Log 2, line up pin landing on Log 2 with pin on Log 1, remainder
of Log 2 rests on the burner tray as shown below.
HZ33CE use bottom
pin landing
Log clips installed
HZ30E
1
2
3
HZ33CE use
bottom pin
landing
1
4
5
2
4
12. Place lava embers/rocks on glass - ensure rocks do not block pilot.
Do not place lava rocks/embers too close to logs as this may cause
carboning.
13. Adjust aeration, see unit manual for setting.
HZ30E use top
pin landing
11. Position Log 3, line up bottom pin landing on Log 3 with pin on
Log 1. The remainder of Log 3 will rest on the burner tray.
14"
2
HZ33CE/HZ30E
