Regency Fireplace Products Cascades F1150, Owners & Installation Manual

Page: 23 / 48

F1150 Regency Freestanding Woodstove
|
23
installation
tooltip
919-714
09.14.16
FAN INSTALLATION
(120V FAN)
1. Remove the two screws from the top of the fan housing.
2. Slide the fan up into the rear heat shield.
3.
After aligning holes, secure the fan to the rear heat shield using
the two screws removed earlier.
Note: The connection cord should not be in contact with any
hot surfaces.
WARNING: FAN ASSEMBLY MUST BE DISCONNECTED FROM
THE SOURCE OF ELECTRICAL SUPPLY BEFORE
ATTEMPTING THE INSTALLATION.
FAN OPERATION
The fan is controlled by a rheostat which allows control of the heat
output.
The fan will turn on as the stove has come up to operating temperature.
It will also shut the fan system off after the fire has gone out and the
unit cooled to below a useful heat output range.
If the fan cycles on and off continuously the thermo switch sensor is
not making contact with the stove body. Remove the fan, bend the
bracket closer to the stove and re-install the fan.
The fan is to be operated in the <LOW> position when burning in the
LOW - MED LOW heat output setting and on <HIGH> when burning
in the MED-HIGH settings.
Wire98gr.eps
updated Jan. 27/00
updated: Aug. 09/05
capitalized the word Nut
Lockwasher
Ground wire
from power cord
Ground wire
from fan
#8 Groun Lug d
Star washer
Nut
Nut
Star washer
Grounding
Lug Detail
CAUTION: Label all wires prior to disconnec-
tion when servicing controls. Wiring errors
can cause improper and dangerous operation.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against shock
hazard and should be plugged directly into a prop-
erly grounded three-prong receptacle. Do not cut or
remove the grounding prong from this plug.
Wiring Diagram
F1500
FAN
BLACK
ON
RHEOSTAT
GREEN
___l_ -==-
THERMODISC
BLACK
GRND
Fan assembly for use only with the room heater marked to indicate such use.
Fan Installation
NORMALLY OPEN