As population increases, municipal water and wastewater
treatment facilities must also increase in size in order to supply
and treat the greater demand for water. As the plants increase
in size, so do the distribution and piping systems carrying this
water to and from the population. These piping systems cover
many, many miles making it difficult to maintain suitable
disinfection and stable residuals using manual chlorine,
sulfur dioxide and ammonia gas feed systems.
The REGAL SMARTVALVES™ discussed in this bulletin solve
the problem whenever varying water flow needs to be
controlled accurately (and automatically) to provide the
correct ratio of chemical to water at all times. NO WASTED
CHEMICAL.
Model 7001......................................................................Flow Proportional Control (10 to 500 PPD)
Model 7006....................................................................Flow Proportional Control (1000/2000 PPD)
REGAL SMARTVALVE
™
Models 7001 and 7006
Flow Proportional Control
INTRODUCTION
1. All software including design, appearance, algorithms, and source
codes are copyrighted and owned by Chlorinators Incorporated.
2. The entire contents of this manual
MUST
be read and under-
stood prior to installing and operating this equipment.
3.
DO NOT
discard this instruction manual upon completion of the
installa tion as this manual contains information essential to the
safe handling, operation, and maintenance of this equipment.
4. Additional instruction manuals are available at nominal cost
from Chlorinators Incorporated.
5. Plastic pipe or tubing connector fittings may be broken or
damaged if tightened excessively.
HAND TIGHTEN ONLY.
6. For optimum operation, the installation should be indoors so
that the minimum and maximum temperature limitations as
listed in the “TECHNICAL SPECIFICATIONS” section of this
manual are not exceeded.
IMPORTANT NOTES
WARNINGS
INSTRUCTION BULLETIN 17000
1. This equipment is suitable for use only with the gases specified.
DO NOT USE THIS EQUIPMENT WITH OTHER GASES.
Such
use can result in failures having hazardous consequences.
2. This equipment is designed FOR VACUUM SERVICE
ONLY.
3. To insure proper and safe operation of this equipment, use only
REGAL parts. The use of non-REGAL parts can result in equip-
ment failures having hazardous consequences and voids the
REGAL warranty and insurance coverage.
4. Maintenance should be performed by competent personnel
familiar with this type of equipment, such as Chlorinators
Incorporated themselves.
5. It is essential that all external wiring be done exactly as shown
on the wiring diagrams depicted in this manual. Incorrect wiring
or improper grounding of this equipment
WILL
cause improper
operation and presents a safety hazard.
6. Field wiring
MUST
conform to national and local electrical codes.
7.
DISCONNECT POWER
BEFORE
removing the cover or
servicing this equipment.
8.
ALWAYS
make sure that the cover is in place and securely
fastened to prevent the entry of moisture, water, or corrosive
gases and also to eliminate the potential for electric shock.
9. Any equipment powered by AC line voltage presents a potential
shock hazard. Installation and servicing of this equipment
should only be attempted by qualified electronics technicians.
10. This non-metallic enclosure
DOES NOT
automatically provide
grounding between the conduit connections. Grounding
MUST
be provided as part of the installation.
11. Damage to the circuit boards or internal components incurred
by drilling the enclosure for field wiring or connecting power
lines to low voltage signal terminals voids the warranty.
12. Changing parameter settings and selections
WILL
affect the
operation of this equipment. If unsure, consult Chlorinators
Incorporated
BEFORE
changing parameters or selections.
1044 SE Dixie Cutoff Road, Stuart, Florida 34994 USA
Phone: (772) 288-4854 Fax: (772) 287-3238
www.regalchlorinators.com Email: [email protected]