Regal RH40, User Manual

Page: 44 / 90

44
M37: Alarm #1 Low
Limit
Alarm #1 lower threshold setup. Below this threshold the #1 Alarm will be
triggered. There are two alarming methods. User must select the alarming
output items from window M33 or M36
#1 High
Limit
Alarm #1 upper threshold setup.
#2 High
Limit
Alarm #2 upper threshold setup.
#2 Low
Limit
Alarm #2 lower threshold setup.
M38: Batch
Control
Window to access the built-in batch controller.
Totalizer M4(1): Flo
Multiplier
Window to set the totalizer multiplying factor for the flow rate. The multiplying factor
ranges from 0.001 to 10000.
M4(2): Flo
NET ON/OFF
Window for turning on or off the NET totalizer
M4(3): Flo
POS ON/OFF
Window for turning on or off the POS totalizer.
M4(4): Flo
NEG
ON/OFF
Window for turning on or off the NEG totalizer.
M4(5): Flo
TOT Reset
Window for: (2) Totalizer reset
(3) Restore the factory default settings. Press the dot key followed by the backspace
key. Attention, it is recommended to make notes on the parameters before doing the
restoration.
M4(6):Eng
Multiplier
Window to set the multiplying factor for the Eng totalizer.
M4(7): Eng
TOT Reset
Window to reset the Eng totalizer.
M4(8): Daily
TOT
Window to set up for daily totalizer.
M4(9):
Monthly
TOT
Window to set up for monthly totalizer.
M4(10):
Yearly TOT
Window to set up for yearly totalizer.
System M51:
Language
Window to set up the language Selection – English or Chinese.
M52: Unit
Metric/
English
Window for selecting unit system. ‘Metric’ is the factory default. The
conversion from English to Metric or vice versa will not affect the unit for
totalizers.
Flow
rate unit
Change
Volume
Window for selecting flow rate unit system.
Flow rate can be in:
1. Cubic meter short for (m
3
)
2. Liter (l)
3. USA gallon (gal)
4. Imperial Gallon (igl)
5. Million USA gallon (mgl)
6. Cubic feet (cf)
7. USA oil barrel (bal)
8. Imperial oil barrel (ib)
Change
Time
The flow unit in terms of time can be per day, per hour, per
minute or per second. So there are 36 different flow rate units
in total for selection.
Flow
rate TOT
Unit
Window for selecting flow rate totalizer unit system.
This can be in:
1. Cubic meter short for (m
3
)