Regal Century EVQ165, Installation Manual And User'S Manual, Page: 15 / 20

15
NOTE: The motor start time begins when power is initially applied to the
motor. If the user changes the schedule and does not cycle power to the
motor, the start time of the new schedule will remain the same as the
previous schedule.
5.0 PRIMING
The VGreen Evo™ motor will always run the priming sequence when starting
from the stopped position, except when a schedule is selected that does not
include a priming sequence. The prime setting is 3450 RPM for 3 minutes.
6.0 FREEZE PROTECTION
In the event that the outside air temperature drops below 39°F, the VGreen Evo
motor will automatically turn on and circulate the pool water. The Freeze
Protection will run according to the following conditions (utilizing the factory
default settings):
Freeze Protection Turn On Temperature = 39°F
Freeze Protection Duration = 1 Hour
Freeze Protection Speed = 1725 RPM
Once this one hour period has elapsed, the VGreen Evo motor will check the
ambient temperature again. If the temperature is still below the set threshold,
the VGreen Evo motor will run for an additional 1 hour.
If the temperature is above the threshold, the VGreen Evo motor will
automatically return to the 24-hour based schedule.
7.0 CARE AND MAINTENANCE
The VGreen Evo motor is both reliable and robust in harsh environments.
However, general care and maintenance should be followed to ensure optimum
reliability of this product. It is recommended to always a install a new mechanical
shaft seal when installing a new replacement motor, and follow these monthly
care and maintenance steps.
1. Check for leaks and low water levels – Inspect equipment and plumbing
for water leaks around the equipment pad. A water or air leak may be
present if:
• Moisture is present around the base of the pump
• Water is leaking from any plumbing or other equipment
• Air bubbles are present in the pump basket or pool returns
Contact a qualified pool service professional to repair any leaks and prevent
your pump running dry which could lead to water damage and bearing failure.
2. Clear debris and ensure proper ventilation – Clean the fan inlet on the back
of the VGreen Evo motor and keep the surrounding area free of large debris
such as leaves, branches, mulch, plastic bags, chemical storage, etc.