Regada SPR 0.1PA, Installation, Service And Maintenance Instructions, Page: 4 / 41

2 SPR 0.1PA
1. General data
1.1 Purpose and applications
Electric part-turn actuators REMATIC (hereinafter referred as EA only) with the DMS electronic
control of the SPR 0.1PA type are set up by the program to be controlled on the 24 V DC voltage level;
are set up by the program to be controlled by
analogue input signal.
Electric part-turn actuators are high-powered electric-mechanical products designed for direct
installations onto controlled devices (regulating bodies - valves, etc.). EA of SPR 0.1PA types are
provided for remote control of closing bodies, or for automotive control of regulating bodies in both
directions of their movement.
They can be equipped with means of measuring and control of technological processes where
an unified analogue direct current or voltage signal is an information bearer on their input and/or
output. They can be used in heating, energy, gas, air-conditioning and other technological systems,
which they are suitable for, regarding their features. They are connected with controlled devices with a
flange according to ISO 5211 and
connecting component
or using a stand and
connecting component /
lever.
Note:
1. t is forbidden to use EA as a lifting mechanism!
1.2 Safety instructions
EA of SPR 0.1PA types are reserved technical devices with higher rate of danger, with
possibility of installation in areas specially danger regarding casualties caused by electric
current.
Electric actuators are according to directive LVD 2014/35/EU and standard IEC 61010-1 assigned for
installation category II (overvoltage category).
1.2.1 Product influence to environment
Electromagnetic compatibility (EMC): the product complies with the requirements of the Directive
2014/30/EU of the European Parliament and of the Council on the approximation of the laws the
Member States relating to the electromagnetic compatibility and with the requirements of standards as
well EN 61000-6-4+A1, EN 61000-6-2, EN 61000-3-2+A1+A2 and EN 61000-3-3 within valid edition.
Vibrations caused by the product: product influence is negligible.
Noise produced by the product:
The maximum allowable noise level (A) of the product measured in a
place of operation is 62 dB (A) .
1.2.2 Requirements for professional qualification of people performing installation,
service and maintenance
Electric connection can be performed only by an acquainted person, i.e. an electrical engineer with
professional education of electrical engineering at an apprentice school or a technical
school (secondary, complete secondary or university education) and whose qualification
was verified by an educational facility authorized to verify professional qualification.
1.2.3 Instructions for stuff training
Service can be performed only by workers professionally qualified and trained by the
producer or contracted service centre.