Regada Rematic, Installation, Service And Maintenance Instructions, Page: 28 / 46

26 STR 0PA
Table 3 setting error flags and warning flags as at the delivery
PARAMETER ERROR WARNING
ESD X
Analog Input X
Wrong command X
Torque X
Torque check X
Torque calibration X
Regulator calibration X
Stroke (turns sum) X
Wrong position X
Spin X
Spin direction X
RAM X
ROM X
EEPROM X
Bus X
I2C X
Reset X
V5V X
Parameters X
Set mode X
Relay X
Temperature < X
Temperature > X
Phase X
Power frequency X
Thermal fuse X
Manual control X
Position module X
Position module type X
Position sensor 1 X
Position sensor 2 X
Position sensor 3 X
Position sensor 4 X
Torque module X
Torque module type X
Torque sensor X
LED module X
LED module type X
LCD module X
LCD module type X
Power Supply/Relay module X
Power Supply/Relay module type X
Notes: X – the error or warning flag is activated.
With the error flag , the EA takes the positron defined for the FAILURE REACTION function
eventually stops (depending on the kind of the error), and it will not operate until the error is removed.
With the
warning flag , the EA continues in operation.
The user is advised on error or warning through the READY relay (according to the relay setting)
flickering LED ERROR on the control unit or such error is identifiable through the program after
connecting a PC to the EA
One of the possible errors may be that the button disconnecting the gear after the manual
control was not released to motor control position. In this case the EA will stop after certain
time of motor operation.
Note 1 : in some cases having the error removed the electric actuator must be restarted by switching-off the
voltage supply to the electric actuator for about 3 sec.
Note 2 : in case a manual control action is finished and the control button isn’t returned to the position for
the motor operation, after a certain time the control unit evaluates such condition as the error No 44 and
signals it by the flickering LED ERROR on the control unit or such error is identifiable through the program
after connecting a PC to the EA.
The EA remains stopped until the error is removed. Once the manual