Regada Rematic STR 1PA, Installation, Service And Maintenance Instructions, Page: 40 / 65

38 STR 1PA, STR 2PA
Table 4 setting error flags and warning flags as at the delivery
PARAMETER ERROR WARNING
ESD X
Analog Input – not valid for Modbus/Profibus protocol X
Modbus/Profibus activity – only for Modbus/Profibus protocol X
Wrong command X
Torque X
Torque check X
Torque calibration X
Regulator calibration X
Stroke (turns sum) X
Wrong position X
Spin X
Spin direction X
RAM X
ROM X
EEPROM X
Bus X
I2C X
Reset X
V5V X
Parameters X
Set mode X
Relay X
Temperature < X
Temperature > X
Phase X
Power frequency X
Thermal fuse X
Manual control X
Position module X
Position module type X
Position sensor 1 X
Position sensor 2 X
Position sensor 3 X
Position sensor 4 X
Torque module X
Torque module type X
Torque sensor X
LED module X
LED module type X
LCD module X
LCD module type X
Power Supply/Relay module X
Power Supply/Relay module type X
E2P X
Profibus Channel 1- only for version with Profibus X
Profibus Channel 2- only for version with Profibus X
Notes: X – the error or warning flag is activated.
With the error flag , the EA takes the positron defined for the FAILURE REACTION function eventually
stops (depending on the kind of the error), and it will not operate until the error is removed.
With the
warning flag , the EA continues in operation.
The user is advised on error or warning through the READY relay (according to the relay setting), by
LED ERROR blinking on Control unit, by ERROR message on LED or LCD display, eventually through
the program after connecting the EA with a PC
Note 1 : In some cases having the error removed the electric actuator must be restarted by switching-
off the voltage supply to the electric actuator for about 3 sec.
If some EA element would fail it can be replaced with a new one. The producer’s service centre only
is allowed for such replacement.